Filter
Top Products
Recommended
Tools
Note: Failure to follow an installation procedure could result in damage to equipment or
personal injury.
Additional warnings will be displayed throughout this manual for your awareness. These
warnings can be identified in warning boxes as shown in the following sample.
Andrew disclaims any liability or responsibility for the results of improper or unsafe
installation, operation or maintenance practices.
Andrew supplies all appropriate hardware/parts required for the installation of your 4.5-
Meter Earth Station Antenna. All tools necessary for the installation process should be
provided by the installation crew. Andrew recommends that the following tools be used
for a proper installation of the 4.5-Meter Earth Station Antenna.
Table 1. Recommended Tools
Tool Size Qty.
Open End Wrench 1/4“ 2
3/8“ 2
1/2“ 2
9/16” 2
5/8” 2
3/4” 2
7/8“ 2
1-1/4” 1
Drive Sockets 7/16” 2
9/16” 1
3/4” 1
7/8” 1
1-1/16” 1
1-1/4” 1
Spud Wrench 1-1/16“ 1
Breaker Bar 1/2” 1
Screw Driver Standard 1
Phillips 1
Allen Wrench 1/2“ 1
Tape Measure Standard 1
Felt-tip Marker Standard 1
Hammer Standard 1
Rubber Mallet Standard 1
Pry Bar Standard 1
Tin Snips Standard 1
Crane 1 Ton Minimum Capacity 1
Rope/Cord (2000 lb breaking strength) 50 ft 1
Shackles 5/8“ 2
Ladder 10 Foot Extension 1
Nylon Web Sling 3” x 3’ 2
7
Getting Started