Filter
Top Products
Reflector-to-Mount
Assembly
(With Crane)
Step 1
Step 2
36
Installation Procedures
This reflector can be installed on the mount manually or by using a crane. However,
Andrew recommends that this procedure be performed using a crane.
The following steps provide the procedure for installing the reflector to the mount using
a crane.
Ensure all connections on reflector and back structure are tight.
Wrap crane straps around support angle between pivot brackets as illustrated by Figure
41.
• Hoist reflector slightly off ground to remove diameter setting bands
• Reattach hardware through edge joining plates
Figure 41
ES45T-R Reflector Assembly