Filter
Top Products
Step 11
Step 12
Step 13
41
Installation Procedures
Remove small portion of foam padding from reflector packing crate and install under
bottom portion of reflector assembly to prevent reflector damage during hoisting proce-
dure. Position man at bottom of reflector/backstructure to guide assembly during hoist-
ing procedure.
Hoist reflector/backstructure assembly to vertical position until upper joints of main trian-
gle assembly contact pipe and straddle two locator bars on support and elevation
assembly (P/N 49635) as shown in Figure 49.
Figure 49
Install two U-bolts at each pivot bracket of main triangle assembly.
• Use 1/2 inch (13 mm) lockwashers and nuts.
• Securely tighten U-bolts allowing for some reflector movement
ES45T-R Reflector Assembly