Filter
Top Products
28
Installation Procedures
Step 12
Step 13
Step 14
Install last reflector panel (C-D) by loosely attaching to diameter setting bands and
mounting ring hub. Loosely attach panel seam hardware as installer inside moves
reflector segment to enable segment union.
Loosely attach retaining bar (P/N 49997) to mounting ring hub (P/N 202429). Loosely
attach center plate (P/N 49964-2) to concave side of reflector.
•
Insert capscrew hardware from plate (concave side of reflector) to retaining bar
Insert shim (P/N 200215) between each reflector segment around perimeter of reflector
assembly. Refer to Figure 28B. Tighten setting band and joining plate hardware (P/N
49693).
Panel
Seams (6)
Temporary
Supports (6)
Refer to
Figure 31
Line of Sight
(0.0° Elevation)
Steel Rule
0.03-0.06 Inch
Increment
(0.5-1.0 mm)
Pointed Measuring Rod
6’ (1.8 m)
Reflector
Diameter Setting Band
Temporary Support
12 Inch (300 mm)
Shim Stack - Not
Shown for Clarity
Approx. 10 Feet (3 m)
Theodolite,
Transit or
Laser Level
Reflector
Turn Back
ES45T-R Reflector Assembly
Figure 30
Figure 29