Filter
Top Products
Model MRC88 Page: 55
© 2003 Xantech Corporation
Figure 27: Editing Commands
IR
IN ZONE
(ADVANCED/EXPANDED)
Highlighting a single command in the Macro Command List and selecting Ir In Zone from the pop-up
menu will display another list with Current Zone and Zones 1 thru 8 as choices (for EXPANDED systems,
Zones 1 thru 16 are available for selection).
Current Zone: Selecting Current Zone will route the individual highlighted command from the issuing
Keypad to the corresponding Zone IR port on the rear of the Controller Amplifier - Figure 3-(28) as well
as the In-Zone IR Emitter port on the rear of the Keypad if enabled - Figure 5-(22) (IR Loop-Back
Feature).
Zone 1 (thru 8):
(EXPANDED Zones 1 thru 16): Selecting any of these Zones in the list will route the highlighted IR
command to the selected Zones IR emitter port on the rear of the MRC88 Controller as well as the In-
Zone IR Emitter port on the rear of the Keypad (if enabled) regardless of which zones keypad issued the
command. (i.e. if Zone 2 is selected from the pop-up menu, pressing the associated button on Zone 1’s
keypad will issue that individual command out of the Zone 2 Emitter Ports thereby controlling something
in Zone 2 while in Zone 1). Each command in the macro command list can be assigned to a different
Emitter Port if so desired.
S
OURCE OUTPUT
(ADVANCED/EXPANDED)
Highlighting a single command in the Macro Command List and selecting Source Output from the pop-up
menu will display another list with Current Source and Sources 1 thru 8 as choices.
Current Source: Selecting Current Source will route the individual highlighted command from the issuing
Keypad to the Source Emitter Output port - Figure 3-(26) of the corresponding active source on the
zones keypad.
Source 1 (thru 8): Selecting any of these source selections will route the individual highlighted command
from the issuing Keypad to the selected Source Emitter Output port - Figure 3-(26) regardless of the
active source on that zones keypad.