Filter
Top Products
Page: 18 Model MRC88
© 2003 Xantech Corporation
d) Fast Red Blink = IR Sensor INPUT or Keypad OUTPUT
e) Fast Amber Blink = System BUSY
5. LCD Display. When the zone power is ON, the LCD will indicate the selected source, zone volume level,
zone and system status and other system conditions. The display is automatically backlit when any button
is pressed (backlight is programmable via Dragon Drop-IR™ software).
6. Source 1-4 Selector Buttons. Pressing of Source Button selects the corresponding source’s Audio/Video
signal to be played in the Zone of the keypad pressed. Pressing of the Source Button will reverse the
source icon on the LCD Display and sends IR commands programmed to the button (if any) to the
corresponding source and common emitter outputs as well as Zone Emitter port.
7. Source 5-8 Selector Buttons. Pressing of Source Button selects the corresponding source’s Audio/Video
signal to be played in the Zone of the keypad pressed. Pressing of the Source Button will reverse the
source icon on the LCD Display and sends IR commands programmed to the button (if any) to the
corresponding source and common emitter outputs as well as Zone Emitter port
8. Vol
+. Increases zone volume and moves the Volume Bar on the LCD Display to indicate volume level
(non-programmable).
9. Vol
-. Decreases zone volume and moves the Volume Bar on the LCD Display to indicate volume level
(non-programmable).
10. Mute. Mutes zone speaker output. Sends IR commands programmed to this button (if any) to the selected
source emitter, common emitter, and zone emitter outputs.
11. CH
+. Sends IR commands programmed to this button to the selected source emitter, common emitter,
and zone emitter outputs.
12. CH
-. Sends IR commands programmed to this button to the selected source emitter, common emitter, and
zone emitter outputs.
13. Status. Displays zone and system status. Allows access to Dynamic Zone Linking and Zone EQ/Balance
settings (non-programmable).
14. Select/Play, Stop, Pause, Rew, FF. Each send IR commands programmed to these buttons to the
selected source emitter, common emitter, and zone emitter outputs.