Sony STR-DN1030 Stereo Receiver User Manual


 
98
US
D:\NORM'S JOB\SONY HA\SO120034\STR-DN1030_PMRF
04\4420297141_US\US05ENJ_STR-DN1030-CEL.fm
masterpage: Left
STR-DN1030
4-420-297-14(1)
HDMI Settings menu
You can adjust the required settings for
equipment connected to the HDMI jack.
x Ctrl for HDMI (Control for HDMI)
Lets you turn the Control for HDMI function
on or off. For details, see “Preparing for the
“BRAVIA” Sync” (page 84).
ON
OFF
Notes
When you set “Ctrl for HDMI” to “ON”, “Audio
Out” may be changed automatically.
When the receiver is in standby mode, the
ON/STANDBY indicator on the front panel lights
up in amber if “Ctrl for HDMI” is set to “ON”.
x Pass Through
Lets you output the HDMI signals to the TV
even when the receiver is in standby mode.
ON: When the receiver is in the standby
mode, the receiver continuously outputs
HDMI signals from the receiver’s HDMI
TV OUT jack.
AUTO: When the TV is turned on while the
receiver is in the standby mode, the receiver
outputs HDMI signals from the receiver’s
HDMI TV OUT jack. Sony recommends
this setting if you use a “BRAVIA” Sync
compatible Sony TV. This setting saves
power in the standby mode when compared
with the “ON” setting.
OFF: The receiver does not output HDMI
signals when in standby mode. Turn on the
receiver to enjoy the connected equipment’s
source on the TV. This setting saves power
in the standby mode when compared with
the “ON” setting.
Notes
This function is not available when “Ctrl for
HDMI” is set to “OFF”.
• When “AUTO” is selected, it may take a little more
time for the image and sound to be output to the TV
than when “ON” is selected.
x Audio Out
Lets you set the HDMI audio signals output
from the playback equipment connected to the
receiver via an HDMI connection.
AMP: The HDMI audio signals from the
playback equipment are only output to the
speakers connected to the receiver. Multi
channel sound can be played back as it is.
Note
Audio signals are not output from the TV’s
speaker when “Audio Out” is set to “AMP”.
TV+AMP: The sound is output from TV’s
speaker and the speakers connected to the
receiver.
Notes
The sound quality of the playback equipment
depends on the TV’s sound quality, such as the
number of channels, and the sampling
frequency, etc. If the TV has stereo speakers, the
sound output from the receiver is also in stereo as
that of the TV, even if you play back multi
channel source.
When you connect the receiver to a video
equipment (projector, etc.), sound may not be
output from the receiver. In this case, select
“AMP”.
Network Settings menu
You can adjust the settings for the network.
The Network Settings menu is available only
when the Home Network or SEN function is
selected.
x Settings
Lets you make the network settings. For
details, see “Configuring the network settings
of the receiver” (page 44).
Wireless LAN Settings
Wired LAN Settings
x Information
Lets you check the network information for
the network.