Filter
Top Products
125
US
D:\NORM'S JOB\SONY HA\SO120034\STR-DN1030_PMRF
04\4420297141_US\US07ADD_STR-DN1030-CEL.fm
masterpage: Right
STR-DN1030
4-420-297-14(1)
Additional Information
• If there is equipment that generates
electromagnetic radiation, such as a
wireless LAN, other Bluetooth device, or a
microwave oven nearby, move them
away.
• Turn down the volume of the connected
Bluetooth device.
The Control for HDMI function does not
work.
• Check the HDMI connection (page 27).
• Make sure “Ctrl for HDMI” is set to “ON”
in HDMI Settings menu.
• Make sure the connected equipment is
compatible with the Control for HDMI
function.
• Check the Control for HDMI settings on
the connected equipment. Refer to the
operating instructions of the connected
equipment.
• If you unplug the HDMI cable or change
the connection, repeat the procedures of
“Preparing for the “BRAVIA” Sync”
(page 84).
• When “Ctrl for HDMI” is set to “OFF”,
the “BRAVIA” Sync does not work
properly, even if the equipment is
connected to the HDMI IN jack.
• The types and the number of equipment
which can be controlled by the
“BRAVIA” Sync are restricted in the
HDMI CEC standard as follows.
– Recording equipment (Blu-ray Disc
recorder, DVD recorder, etc.): up to 3
equipment
– Playback equipment (Blu-ray Disc
player, DVD player, etc.): up to 3
equipment
– Tuner-related equipment: up to 4
equipment
– AV receiver (audio system): up to 1
equipment
The remote control does not function.
• Point the remote control at the remote
control sensor on the receiver (page 10).
• Remove any obstacles in the path between
the remote control and the receiver.
• Replace all the batteries in the remote
control with new ones, if they are weak.
• Make sure you select the correct input on
the remote control.
• When you operate a programmed non-
Sony equipment, the remote control may
not function properly depending on the
model and the manufacturer of the
equipment.
If there is a malfunction, a message appears on
the display panel. You can check the condition
of the system by the message. If any problem
persists, consult your nearest Sony dealer.
PROTECTOR
Irregular current is output to the speakers, or
the receiver is covered and ventilation holes
are blocked. The receiver will automatically
turn off after a few seconds. Remove the
object covering the upper panel of the
receiver, check the speaker connection and
turn on the power again.
USB FAIL
An over current from the (USB) port was
detected. The receiver will automatically
turn off after a few seconds. Check the
iPod/iPhone or USB device, then unplug it
and turn on the power again.
For other messages, see “Message list after
Auto Calibration measurement” (page 44),
“iPod/iPhone message list” (page 54), “USB
message list” (page 57) and “Network features
message list” (page 78).
“BRAVIA” Sync (Control for
HDMI)
Remote control
Error messages