Sony STR-DN1030 Stereo Receiver User Manual


 
114
US
D:\NORM'S JOB\SONY HA\SO120034\STR-DN1030_PMRF
04\4420297141_US\US07ADD_STR-DN1030-CEL.fm
masterpage: Left
STR-DN1030
4-420-297-14(1)
This receiver supports security functions
that comply with the Bluetooth specification
to ensure secure connection during
communication using Bluetooth technology.
However, this security may be insufficient
depending on the setting contents and other
factors, so always be careful when
performing communication using Bluetooth
technology.
Sony cannot be held liable in any way for
damages or other loss resulting from
information leaks during communication
using Bluetooth technology.
Bluetooth communication is not necessarily
guaranteed with all Bluetooth devices that
have the same profile as this receiver.
Bluetooth devices connected with this
receiver must comply with the Bluetooth
specification prescribed by the Bluetooth
SIG, Inc., and must be certified to comply.
However, even when a device complies with
the Bluetooth specification, there may be
cases where the characteristics or
specifications of the Bluetooth device make
it impossible to connect, or may result in
different control methods, display or
operation.
Noise may occur or the audio may cut off
depending on the Bluetooth device
connected with this receiver, the
communications environment, or
surrounding conditions.
If you have any questions or problems
concerning your receiver, please consult your
nearest Sony dealer.
Troubleshooting
If you experience any of the following
difficulties while using the receiver, use this
troubleshooting guide to help you remedy the
problem. Should any problem persist, consult
your nearest Sony dealer. Note that if service
personnel changes some parts during repair,
these parts may be retained.
The receiver is turned off
automatically.
“Auto Standby” is set to “ON” (page 102).
The Sleep Timer function is working
(page 16).
“PROTECTOR” is working (page 125).
The ON/STANDBY indicator flashes in
quick succession.
The software update has error. Unplug the
power cord, and then plug in the power
cord again. The receiver will try to update
the software. If the indicator continues to
flash in quick succession, contact your
nearest Sony dealer.
No image appears on the TV.
Select the appropriate input using the input
buttons.
Set your TV to the appropriate input mode.
Move your audio equipment away from
the TV.
Assign the component video input
correctly.
The input signal should be same as the
input function when you are up-converting
an input signal with this receiver
(page 20).
Make sure that cables are correctly and
securely connected to equipment.
Power
Image