Filter
Top Products
118
US
D:\NORM'S JOB\SONY HA\SO120034\STR-DN1030_PMRF
04\4420297141_US\US07ADD_STR-DN1030-CEL.fm
masterpage: Left
STR-DN1030
4-420-297-14(1)
Recording cannot be carried out.
• Check that the equipment is connected
correctly.
• Select the source equipment using the
input buttons (page 50).
• Audio input signals via HDMI IN and
DIGITAL IN jacks cannot be recorded.
• Copyright protection to prevent recording
is contained in the sources. In this case,
you may not be able to record from the
sources.
A test tone is not output from the
speakers
• The speaker cords may not be connected
securely. Check to see if they are
connected securely and cannot be
disconnected by pulling on them slightly.
• The speaker cords may have short-circuit
problem.
• Make sure that you are not using PARTY
STREAMING function (page 74).
A test tone is output from a different
speaker than the speaker displayed on
the TV screen
• The speaker pattern set up is incorrect.
Make sure that the speaker connections
and the speaker pattern match correctly.
When the receiver is in standby mode,
there is no sound output from the TV.
• When the receiver enters into standby
mode, sound is from the last HDMI
equipment selection before you turned off
the receiver. If you are enjoying other
equipment, play the equipment and
perform the One-Touch Play operation, or
turn on the receiver to select the HDMI
equipment you want to enjoy.
• Make sure “Pass Through” is set to “ON”
in the HDMI Settings menu if you connect
equipment not compatible with the
“BRAVIA” Sync to the receiver (page 98).
There is a time gap between the audio
output and visual display.
• Check that the PARTY STREAMING
function is not being used. To close a
PARTY, press SHIFT, then hold down
PARTY until “CLOSE PARTY” appears.
For details, see page 74.
The FM reception is poor.
• Use a 75-ohm coaxial cable (not supplied)
to connect the receiver to an outdoor FM
antennas (aerial) as shown below.
Radio stations cannot be tuned in.
• Check that the antennas (aerials) are
connected securely. Adjust the antennas
(aerials) and connect an external antenna
(aerial), if necessary.
• The signal strength of the stations is too
weak with automatic tuning. Use direct
tuning.
• Make sure you set the tuning scale
correctly (when tuning in AM stations
with direct tuning) (page 59).
• No stations have been preset or the preset
stations have been cleared (when tuning
by scanning preset stations is used). Preset
the stations (page 60).
• Press AMP, then press DISPLAY
repeatedly on the remote control so that
the frequency appears on the display
panel.
Tuner
Receiver
Outdoor FM antenna (aerial)