Filter
Top Products
25
US
D:\NORM'S JOB\SONY HA\SO120034\STR-DN1030_PMRF
04\4420297141_US\US04GET_STR-DN1030-CEL.fm
masterpage: Right
STR-DN1030
4-420-297-14(1)
Connections
* When you connect a subwoofer with an auto
standby function, turn off the function when
watching movies. If the auto standby function is
set to on, it turns to standby mode automatically
based on the level of the input signal to the
subwoofer, and the sound may not be output.
**Notes on the SPEAKERS SURROUND BACK/
FRONT HIGH/BI-AMP/FRONT B terminals
connection.
– If you connect only one surround back speaker,
connect it to L of this terminals.
– If you have an additional front speaker system,
connect them to this terminals.
Set the “SB Assign” to “Speaker B” in the
Speaker Settings menu (page 38).
You can select the front speaker system you
want by using the SPEAKERS button on the
receiver (page 39).
– You can connect the front speakers to this
terminals using bi-amplifier connection
(page 25).
Set the “SB Assign” to “BI-AMP” in the
Speaker Settings menu (page 90).
Note
After you have installed and connected your
speaker, be sure to select the speaker pattern from
the Speaker Settings menu (page 38).
If you are not using surround back speakers
and front high speakers, you can connect the
front speakers to the SPEAKERS
SURROUND BACK/FRONT HIGH/
BI-AMP/FRONT B terminals using a
bi-amplifier connection.
Connect the jacks on the Lo (or Hi) side of the
front speakers to the SPEAKERS FRONT A
terminals, and connect the jacks on the Hi (or
Lo) side of the front speakers to the
SPEAKERS SURROUND BACK/FRONT
HIGH/BI-AMP/FRONT B terminals.
Make sure that metal fittings of Hi/Lo attached
to the speakers have been removed from the
speakers to avoid receiver malfunction.
After you have made the bi-amplifier
connection, set the “SB Assign” to “BI-AMP”
in the Speaker Settings menu (page 90).
Bi-amplifier connection
Hi
Lo
Hi
Lo
Front speaker
(Right)
Front speaker
(Left)