Filter
Top Products
78
Note
Depending on the disc, [Letter Box] may be selected
automatically instead of [Pan Scan] or vice versa.
[Line1 Decoder]
Sets the LINE 1-TV jack for inputting encoded
video signals.
[Progressive Mode] (Viewing in Progressive
format)
Selects whether the COMPONENT VIDEO OUT
jacks output progressive signals.
Notes
• You cannot select [On] if the VIDEO OUT SELECT
switch on the rear panel is set to “RGB.” Make sure that
it is set to “COMPONENT” (page 21).
• When set to [On], pictures appear on a progressive
compatible TV or monitor. Signals are only sent to the
COMPONENT VIDEO OUT jacks in progressive
mode. To cancel the setting, remove the disc and close
the disc tray. Then press and hold x (stop) on the
recorder for five seconds.
• If your TV does not accept progressive signals,
[Progressive Mode] will be set to [Off] automatically
after a few seconds.
[PBC] (Playback Control)
Turns the PBC function on or off when playing
VIDEO CDs.
[ Off ] Inputs the signals from the LINE
1-TV jack. Normally select this.
[ On ] The signal input from the LINE 1-
TV jack is output to the LINE 3/
DECODER jack for decoding.
The decoded signal is then input
back through the LINE 3/
DECODER jack so you can
record or view PAY-TV/Canal
Plus programmes. In this case,
select “LINE 1” by pressing
INPUT SELECT.
[ Off
] Select this when your TV is not
compatible with progressive
signals, or, the TV is connected to
jacks other than the
COMPONENT VIDEO OUT
jacks.
[ On ] Select this when your TV accepts
progressive 625p format signals,
and, the TV is connected to the
COMPONENT VIDEO OUT
jacks. You will enjoy accurate
colour reproduction and high
quality image.
[16:9]
[4:3 Letter Box]
[4:3 Pan Scan]
[ Off ] The PBC function is not
activated. VIDEO CDs with PBC
will be played the same way as
audio CDs.
[ On
] The PBC function is activated
when playing VIDEO CDs with
PBC.