Filter
Top Products
102
TV channels cannot be changed.
, The channel is disabled (page 75).
, A timer recording started, which changed the
channels.
The picture from equipment connected to the
recorder’s input jack does not appear on the
screen.
, If the equipment is connected to the LINE 1-TV
jack, select “LINE 1” in the front panel display
by pressing INPUT SELECT.
If the equipment is connected to the LINE 2 IN
jacks, select “LINE 2” in the front panel display
by pressing INPUT SELECT.
If the equipment is connected to the LINE 4 IN
jacks, select “LINE 4” in the front panel display
by pressing INPUT SELECT.
If the equipment is connected to the LINE 3/
DECODER jack, select “LINE 3” in the front
panel display by pressing INPUT SELECT.
If the equipment is connected to the DV IN jack,
(this is usually for a digital video camera
connection), select “DV” in the front panel
display by pressing INPUT SELECT.
The playback picture or TV programme from
the equipment connected through the recorder
is distorted.
, If the playback picture output from a DVD
player, VCR, or tuner goes through your recorder
before reaching your TV, the copy-protection
signal applied to some programmes could affect
picture quality. Disconnect the playback
equipment in question and connect it directly to
your TV.
The picture does not fill the screen.
, Set [TV Aspect] in [Settings] Setup in
accordance with the aspect ratio of your TV
(page 77).
The picture does not fill the screen, even
though the aspect ratio is correctly set in [TV
Aspect] in [Settings] Setup.
, The aspect ratio of the disc is fixed on your DVD.
The picture is black and white.
, If you are using a SCART cord, be sure to use
one that is fully wired (21 pins).
Sound
There is no sound.
, The connecting cord is damaged.
, The input source setting on the supplied speaker
system or the connection to the speaker system is
incorrect.
, The recorder is in reverse play, fast forward,
slow motion, or pause mode.
, If the audio signal does not come through the
DIGITAL OUT (OPTICAL or COAXIAL)
jacks, check the [Audio] Setup settings
(page 79).
, Press MUTING if “MUTING ON” is displayed
in the centre unit display.
, Check the speaker settings (page 14).
Sound is noisy.
, When playing a CD with DTS sound tracks,
noise will come from the LINE 2 OUT (AUDIO
L/R) jacks, LINE 1-TV jack, or LINE 3/
DECODER jack (page 55).
The sound volume is low.
, The sound volume is low on some DVDs.
For the supplied speaker output, set “AUDIO
DRC” in AMP menu to “DRC MAX” or “DRC
STD” (page 87).
For other sound output, set [Audio DRC] in
[Audio] setup to [On] (page 80).
An alternate audio track cannot be recorded or
played.
, If an audio channel other than “Main+Sub” is
selected, you cannot record both main and sub
sounds. Check the selected audio channel before
you start recording.
, To enjoy bilingual programmes through the
supplied speaker system, select the audio
channel in the “DUAL MONO” setting of the
AMP menu (page 89).
Severe hum or noise is heard.
, Check that the speakers and components are
connected securely.
, Check that the connecting cords are not too close
to a transformer or motor, and at least three
metres away from your TV set or any fluorescent
lighting.
, Move your TV away from the system.
, The plugs and jacks are dirty. Wipe them with a
cloth slightly moistened with alcohol.