Sony DAR-RD100 Stereo System User Manual


 
17
Hookups and Settings
Notes
Use screws that are suitable for the wall material and
strength. As a plaster board wall is especially fragile,
attach the screws securely to a beam and fasten them to
the wall. Install the speakers on a vertical, flat wall
where reinforcement is applied.
Contact a screw shop or installer regarding the wall
material or screws to be used.
Sony is not responsible for accident or damage caused
by improper installation, insufficient wall strength or
improper screw installation, natural calamity, etc.
Step 3: Connecting the FM/
AM Aerials
z Hints
When connecting the AM loop aerial, cord (A) or cord
(B) can be connected to either terminal.
If you have poor FM reception, use a 75-ohm coaxial
cable (not supplied) to connect the system to an
outdoor FM aerial as shown below.
Notes
To prevent noise pickup, keep the AM loop aerial away
from the system and other equipment.
Be sure to fully extend the FM wire aerial.
After connecting the FM wire aerial, keep it as
horizontal as possible.
AERIAL
AM
FM
75 COAXIAL
AM loop aerial
(supplied)
Subwoofer
FM wire aerial (supplied)
A
B
AERIAL
AM
FM
75 COAXIAL
Outdoor FM aerial
(not supplied)
Subwoofer