Pioneer VSX-D714 Stereo Receiver User Manual


 
Additional information
11
70
En
Broadcast stations cannot be
selected automatically.
• Connect an outdoor antenna (refer to page 20).
No sound from surround or
center speakers.
• Refer to
Speaker setting
on page 42 to check the speaker settings.
• Refer to
Manually calibrating your listening area (MCACC)
on
page 48 (with the VSX-D814, you can do this using the
Quick
surround sound setup
on page 13) to check the speaker levels.
• Connect the speakers properly (refer to page 21).
No sound from surround
back speakers.
• Refer to
Surround back speaker setting
on page 43 to check the
surround back speaker settings.
• Refer to
Manually calibrating your listening area (MCACC)
on
page 48 (with the VSX -D814, you can do this using the
Quick
surround sound setup
on page 13) to check the speaker levels.
• Refer to
Using the Surround Back Channel (SB CH)
on page 37 to
make sure the
SB CH MODE
and the sound mode are set for
surround back sound.
No sound from subwoofer. • Make sure the subwoofer is switched on.
• If the subwoofer has a volume knob, make sure it’s turned up.
• Switch the
Subwoofer setting
on page 43 to
YES
or
PLUS
.
• Switch the
LFE attenuator setting
on page 44 to
0 dB
or
10 dB
.
• The Dolby Digital or DTS source you are listening to does not have
an LFE channel.
Noise during playback of a
cassette deck.
• Move the cassette deck further from your receiver, until the noise
disappears.
Sound is produced from
other components, but not
from LD or DVD player.
• Set the
SIGNAL SELECT
to
AUTO
,
DIGITAL
or
ANALOG
according to the type of connections made. (refer to page 36).
• Set the digital input settings correctly (refer to page 46).
• Make digital connections (refer to page 16) and set the
SIGNAL
SELECT
to
DIGITAL
(refer to page 36).
• Refer to the instruction manual supplied with the DVD player.
No sound is output or a noise
is output when software with
DTS is played back.
• Set the digital volume level of the player to full, or to the neutral
position.
When a search is performed
by a DTS compatible CD
player during playback, noise
is output.
• This is not a malfunction, but be sure to turn the volume down to
prevent the output of loud noise from your speakers.
Problem
Remedy
VSX_714_814.fm 70 ページ 2004年1月28日 水曜日 午前10時18分