Filter
Top Products
Additional information
11
71
En
English Italiano Français
Nederlands
EspañolDeutsch
• If the unit does not operate normally due to external effects such as static electricity
disconnect the power plug from the outlet and insert again to return to normal operating
conditions.
Resetting the main unit
Use this procedure to reset all the receiver’s
settings to the factory default. Use the front
panel controls to do this.
1 Switch the receiver on.
2 While holding down the TONE button,
press and hold the
STANDBY/ON
button for about three seconds.
3 When you see RESET? appear in the
display, press the TONE button.
OK?
shows in the display.
4 Press TONE once more to confirm.
OK
appears in the display to indicate that the
receiver has been reset to the factory default
settings.
Switching the speaker
impedance
We recommend using speakers of 8
Ω
with
this system, but it is possible to switch the
impedance setting if you plan to use speakers
with a 6
Ω
impedance rating.
• With the receiver in standby, press
STANDBY/ON while holding down the
SPEAKERS button.
Each time you do this, you switch between the
impedance settings:
•
SP 6 OHM
– Use this setting if your
speakers are rated at 6
Ω
.
•
SP 8 OHM
– Use this setting if your
speakers are rated at 8
Ω
or more.
Can’t operate the remote
control.
• Replace the batteries (refer to page 5).
• Operate within 7 m, 30° of the remote sensor on the front panel
(refer to page 5).
• Remove the obstacle or operate from another position.
• Avoid exposing the remote sensor on the front panel to direct light.
The display is dark or off. • Press
FL DIMMER
on the remote control repeatedly to return to
the default.
Problem
Remedy
VSX_714_814.fm 71 ページ ２００４年１月２８日 水曜日 午前１０時１８分