Filter
Top Products
Setting up the receiver
07
49
En
English Italiano Français
Nederlands
EspañolDeutsch
4 Specify the distance from the front left
speaker to your listening position using
and
then press ENTER.
5 Use
and
to adjust the delay for
each channel in turn, pressing ENTER to go
to the next channel when you’re done.
Listen to the reference channel and use it to
measure the target channel. Stand facing the
two speakers with your arms outstretched
pointing at each speaker. Try to make the two
tones sound as if they are arriving simulta-
neously at a position slightly in front of you
and between your arm span.
The test tone for channel delay is output in the
same order as step 5:
After you have completed all the channels in
your speaker setup, the volume level returns
to normal and
COMPLETE
, then
RESUME
shows in the display.
• Using the MCACC system to set up your
speaker system will overwrite any
previous settings you had for the
STANDARD
or
ADVANCED SURROUND
modes.
Setting separate channel
levels for listening modes
• Default setting:
0 dB
In addition to the MCACC setup, you can also
set relative channel levels from the listening
position using the method below. Using
CH
SELECT
(see tip below), it is also possible to
set separate channel levels for each of the
listening modes.
1 Press STANDARD or ADVANCED
SURROUND.
2 Press TEST TONE to output the test
tone.
The test tone is output in the following order
(depending on the speaker setting):
• If you don’t hear a test tone from one of
your speakers, please refer to
Speaker
setting
on page 42 and
Surround back
speaker setting
on page 43 to make sure
you have correctly specified your speaker
setup.
RC
RS
LS
SW SB
STANDARD
SURROUND
ADVANCED
LEVEL
TEST
TONE
MASTER
V OLUME
CH
SELECT
LC
RS
R
LS
SW SB
VSX_714_814.fm 49 ページ ２００４年１月２８日 水曜日 午前１０時１８分