Filter
Top Products
Using the tuner
08
56
En
• If you see
NO RADIO TEXT DATA
in the
RT display, it means no RT data is
transmitted from the broadcast station. If
you have entered a name for the station, it
is broadcast instead of RT data. If you
haven’t, the display will automatically
switch to the PS data display. If no PS
data is transmitted from the station, the
frequency will be displayed.
• In the PTY display, there are cases where
NO DATA
is shown. If this happens, the
PS display is shown after a few seconds.
• This unit converts lower case characters
transmitted by broadcast stations to
upper case characters.
• If reception conditions are strong but the
RDS data is displayed incorrectly, press
RF ATT
.
Searching for RDS programs
One of the most useful features of RDS is the
ability to search for a particular kind of radio
program. You can search for any of the
program types listed on the previous page.
1 Press the BAND button to select the
FM band.
RDS is only possible in the FM band.
2 Press the PTY SEARCH button.
SEARCH
shows in the display.
3 Use the MULTI JOG dial to select the
program type you want to hear.
4 Press ENTER to search for the program
type.
The system starts searching through the
station presets for a match. When it finds one,
the search stops and the station plays for five
seconds.
5 If you want to keep listening to the
station, press ENTER within the 5 seconds.
If you don’t press
ENTER
, searching resumes.
If
NO PTY
is displayed it means the tuner
couldn’t find that program type at the time of
the search.
• RDS searches station presets only. If no
stations have been preset, or if the
program type could not be found among
the station presets
NO PTY
is displayed.
FINISH
means the search is complete.
An introduction to EON
When EON (Enhanced Other Network
information) is turned on, the receiver jumps
to an EON-linked broadcast when it begins,
even if a receiver function other than the tuner
is being used. It can’t be used in areas that
EON information isn’t transmitted and when
FM broadcast stations don’t transmit PTY
data. When the broadcast ends, the tuner
returns to the original frequency or function.
STATION
STANDARD
DIGITAL IN
ADVANCED
SURROUND
STEREO/
DIRECT
SIGNAL
SELECT
PTY
SEARCH
EON
MODE
MIDNIGHT/
LOUDNESS
TUNING
LISTENING MODE
TUNER EDIT
CLASS
BAND
MPX
MULTI JOG
SETUP MIC
UPDOWN
MULTI JOG
MASTER VOLUME
ENTER
SPEAKERS
S-VIDEODIGITAL INSETUP MIC VIDEO
L AUDIO R
/
SIGNAL
SELECT
MIDNIGHT/
LOUDNESS
SB CH
MODE
TONE
QUICK SETUP
MCACC
VIDEO INPUT
MULTI JOG
VSX_714_814.fm 56 ページ ２００４年１月２８日 水曜日 午前１０時１８分