Filter
Top Products
Listening to your system
06
40
En
Playing other sources
1 Turn on the power of the playback
component.
2 Turn on the power of the receiver.
3 Select the source you want to play-
back.
Use the
MULTI CONTROL
buttons (or
INPUT
SELECT
).
4 Start playback of the component you
selected in step 1.
Selecting the multichannel
analog inputs
If you have connected a decoder or a DVD
player with multichannel analog outputs to
this receiver (page 18), you must select the
analog multichannel inputs for surround
sound playback.
1 Press DVD/LD on the remote control or
the front panel.
2 Press SIGNAL SELECT (front panel)
repeatedly to select DVD 5.1ch.
To cancel playback from the multichannel
inputs, use the
SIGNAL SELECT
button to
select a different input signal.
• When playback from the multichannel
inputs is selected, you can’t use the
INPUT ATT
,
TONE
, and
MIDNIGHT/
LOUDNESS
buttons, as well as the
STAN-
DARD
,
ADVANCED SURROUND
, and
STEREO/DIRECT
sound modes.
• When playback from the multichannel
inputs is selected, only the volume and
channel levels can be set.
Using the sleep timer
The sleep timer switches the receiver into
standby after a specified amount of time so
you can fall asleep without worrying about the
receiver being left on all night. Use the remote
control to set the sleep timer.
1 Press RECEIVER.
2 Press SLEEP repeatedly to set the sleep
time.
• You can check the remaining sleep time
at any time by pressing
SLEEP
once.
Pressing repeatedly will cycle through the
sleep options again.
• You can also switch off the sleep timer
simply by switching off the receiver.
MULTI CONTROL
RECEIVER
DVD/LD
TV/SAT
INPUT SELECT
CD
VCR/DVR TV CONT
TUNER
CD-R/TAPE
STANDARD SPEAKERS
S-VIDEODIGITAL INSETUP MIC VIDEO
L AUDIO R
ADVANCED
SURROUND
STEREO/
DIRECT
SIGNAL
SELECT
MIDNIGHT/
LOUDNESS
SB CH
MODE
LISTENING MODE
TONE
QUICK SETUP
MCACC
VIDEO INPUT
MULTI JOG
PTY
SEARCH
EON
MODE
Off
90 min 60 min
30 min
VSX_714_814.fm 40 ページ ２００４年１月２８日 水曜日 午前１０時１８分