Filter
Top Products
4.3 Initial Settings
The internal registers and switches are set to the following conditions when power
is turned on. The settings are not re-initialized when the player is put into Park or
Door Open Mode. Do not forget to set them to the parameters needed when creating
an application program. Some of the switch settings can be set only via Register
Commands under computer control; others can be set by using the DIP Switches
on the rear panel of the player or via Registers. For more information see Section
4.7.6 Register Control Commands, page 4-39, and Section 2.4 Function
Switch Settings, page 2-13.
Chapter Four • CLD-V2600 / 2400 Level I & III
Register/Switch Initial Setting Status
Key lock 0 Unlocked
Video switch 1 ON
Audio switch 7 Digital Stereo
(If digital audio is
encoded on the disc.)
Display switch 0 OFF
Address flag 3 Frame - CAV; Time - CLV
Track - CD, CDV
Speed parameter 60 Normal (X1) speed
Communication
Control Mode 3 Automatic Status
REG. A 3 Frame/Chapter - LD;
Track/Time - CD, CDV
REG. B 0 Normal squelch
REG. C 1 Side Repeat ON and Blue
Squelch. (Load Start, Power
On Start and BAUD Rate can
be set using SW 1 & 2 on the
players’ back panel. Squelch
color of Blue or Black can
be selected with SW 3 on the
back of the CLD-V2600).
These options can also be set
through Register C under
Level III control.
4-4 TP 117 v. 2.0 • 12/93 CLD-V2600 / 2400 Level I & III User’s Manual
Figure 4-D