Pioneer CLD-V2400 CD Player User Manual


 
1) REJECT
Function: Pressing this button is effective only when the player is in Spin Up or
Random Access Mode. When this command is sent to the player, the active mode
of the player is changed to Spin Down, processing waits until the spindle stops,
and then the active mode is changed to Park. NOTE: This button cannot be used
to open or close the player’s disc drawer; it is used to put the player into Park.
2) PAUSE
Function: Pressing this button causes the player to cease playback temporarily.
Explanation: The player enters Pause Mode when the PAUSE button is pressed.
In Pause Mode, video is squelched. Press PLAY or any other motion button to exit
Pause Mode. NOTE: The PAUSE button does not toggle PAUSE ON and OFF. To exit
Pause Mode issue a motion command (PLAY, STEP FWD/REV, MULTI-SPEED
FWD/REV) or send a SEARCH command.
3) PLAY
Function: Pressing this button starts the player and plays the LaserDisc or CD.
Explanation: The operation performed when the PLAY button is pressed differs
depending on the active mode of the player:
While the disc tray door is opening or when the door is open If this button is
pressed while the door is opening or when the door is open, the player closes
the door. After the door is closed, the player enters Park Mode and then
determines whether a disc is in the drawer. If there is no disc in the drawer,
the player does nothing. If there is a disc in the drawer, it proceeds through the
operations described in Park Mode below.
In Park Mode In Park Mode the player determines whether or not there is a disc
in the disc tray. If there is no disc, the player does not operate. If there is a
disc, the player enters Spin Up Mode and spins-up the disc. When Spin Up Mode
ends, the player enters Random Access Mode and begins playing the disc.
In Random Mode (when search is not in progress) - The player starts playing disc.
During a search - After the search ends, the player starts playing the disc.
NOTE: Audio is not squelched while the disc is playing. When the lead-out area is
reached during normal play, the player automatically spins down the disc, enters
Park Mode and waits for one of several specific instructions — to reject the disc by
pressing the OPEN/CLOSE button on the front of the player, to play the disc again
by pressing PLAY on the front of the player or on the remote control, or to turn off
the player by pressing the Power-OFF button on the front of the player.
If the “Repeat Side” Function has been set to ON, the player automatically searches
to the beginning of the disc and plays it again when lead-out is encountered. See
Section 2.4 Function Switches, page 2-13.
Chapter Three • CLD-V2600 / 2400 Level I & III
3-6 TP 117 v. 2.0 12/93 CLD-V2600 / 2400 Level I & III User’s Manual