Onkyo NR906 Stereo System User Manual


 
96
Advanced Setup—Continued
5
Use the Up and Down [ ]/[ ] but-
tons to select “Subwoofer”, and
then use the Left and Right
[ ]/[ ] buttons to select:
Yes: Select if a subwoofer is con-
nected.
No: Select if no subwoofer is con-
nected.
Note:
The same setting is used for Speakers A
and Speakers B.
6
Use the Up and Down [ ]/[ ] but-
tons to select “Front”, and then
use the Left and Right [ ]/[ ]
buttons to select a crossover fre-
quency.
Notes:
This setting can be set independently
for front Speakers A and front
Speakers B.
Fixed at “Full Band” if “Subwoofer”
(step 5) is set to “No”.
7
Use the Up and Down [ ]/[ ] but-
tons to select “Center”, and then
use the Left and Right [ ]/[ ]
buttons to select a crossover fre-
quency.
If no center speaker is connected, select
None.
Notes:
The same setting is used for Speakers
A and Speakers B.
Can be set if the currently selected
speakers (Speakers A or Speakers B)
is set to “BTL” (page 61).
Cannot select “Full Band” if “Front”
(step 6) is set to anything other than
“Full Band”.
For Speakers B, if any channel is set
to “Full Band”, “Center” is fixed at
“Full Band”.
8
Use the Up and Down [ ]/[ ] but-
tons to select “Surround”, and
then use the Left and Right
[ ]/[ ] buttons to select a cross-
over frequency.
If no surround left and right speakers
are connected, select “None”.
Notes:
The same setting is used for Speakers
A and Speakers B.
Can be set if the currently selected
speakers (Speakers A or Speakers B)
is set to “BTL” (page 61).
Cannot select “Full Band” if “Front”
(step 6) is set to anything other than
“Full Band”.
9
Use the Up and Down [ ]/[ ] but-
tons to select “SurrBack”, and
then use the Left and Right
[ ]/[ ] buttons to select a cross-
over frequency.
If no surround back speakers are con-
nected, select “None”.
Notes:
The same setting is used for Speakers
A and Speakers B.
Cannot be set if “Speaker Type:
Front(Speaker A) or Front(Speaker
B)” is set to “Bi-Amp” or “BTL”
(page 61), “Surround” is set to
“None” (step 8), or “Powered
Zone2” is being used (page 132).
Cannot select “Full Band” if “Sur-
round” (step 8) is set to anything
other than “Full Band”.
10
Use the Up and Down [ ]/[ ] but-
tons to select “SurrBack Ch”,
and then use the Left and Right
[ ]/[ ] buttons to select:
1ch: Select if one surround back
speaker is connected.
2ch: Select if two (left and right)
surround back speakers are
connected.
Notes:
The same setting is used for Speakers
A and Speakers B.
Cannot be set if “Speaker Type:
Front(Speaker A) or Front(Speaker
B)” is set to “Bi-Amp” or “BTL”
(page 61), “SurrBack” is set to
“None” (step 9), or “Powered
Zone2” is being used (page 132).
Continue with step 11 on the next page.