Filter
Top Products
5-17
The MODE ADJUST Menu
SDP-40
CUSTOM
The CUSTOM menu can be used to
compare modified listening mode versions
to their original, factory-default versions.
CUSTOM VS PRESET
CUSTOM VS PRESET allows comparison
listening of the modified and factory-default
versions of the selected listening mode. This
option is available even when no
modifications have been made to the selected listening mode. But
the custom and preset versions of the listening mode will sound the
same until modifications are made.
Selecting CUSTOM VS PRESET accesses the pulldown menu
pictured at the right. Pressing the up and down MENU arrows
toggles between the modified and factory-default versions of the
selected listening mode. The message “CUSTOM” appears when
the modified version of the listening mode is selected, and the
message “PRESET” appears when the factory-default version of the
listening mode is selected. Press the left MENU arrow to close the
CUSTOM VS PRESET pulldown menu.
RESET MODE
RESET MODE restores the selected listening
mode to its factory-default condition.
Selecting this option accesses the pulldown
menu pictured at the right. Press the right
MENU arrow to restore the factory-default
version of the selected listening mode. Press the left MENU arrow
to exit the RESET MODE pulldown menu without restoring the
selected listening mode to its factory-default settings.
OUTPUT LEVELS
The OUTPUT LEVELS menu contains parameters for adjusting
CENTER, SIDE L/R, REAR L/R, SUBWOOFER L/R, and LFE output
levels on a per-mode basis.
The OUTPUT LEVELS menu is not available for listening modes that
do not accommodate multi-channel outputs, such as MONO. For
these listening modes, the OUTPUT LEVELS menu option appears
as an output-specific parameter, such as CENTER LVL.
Default
Parameter Value Values
CENTER +0dB OFF, -30 to +12dB
SIDE L/R +0dB OFF, -30 to +12dB
REAR L/R +0dB OFF, -30 to +12dB
SUB L/R +0dB OFF, -30 to +12dB
*LFE +0dB OFF, -30 to +12dB
*The LFE parameter is only available for 5.1-channel listening modes.
An alphabetical listing of parameter descriptions begins on page 5-20.
When a SYNTHESIS 7CH SETUP is selected, the LFE parameter will
appear on the OUTPUT LEVELS menu for the 5.1 THX SURROUND
EX or 5.1 THX and dts(-ES) THX listening modes. This parameter
only has an effect when the LFE parameter on the CUSTOM SETUP
menu is set to ON (page 3-23).
(LISTENING MODE)
CUSTOM
MODE ADJUST
(LISTENING MODE)
OUTPUT LEVELS
MODE ADJUST
CUST
OM
CUSTOM VS PRESET
PRESS RIGHT V
TO RESTORE MODE
CUSTOM
CUSTOM VS PRESET
CUSTOM
CUSTOM
CUSTOM VS PRESET
RESET MODE