Filter
Top Products
3-30
The SETUP Menu
JBL
REAR PANEL CONFIG
8 STEREO INPUTS
OR
5 STEREO & 5.1 ANLG
SETUP
INPUTS
SPEAKERS
REAR PANEL CONFIG
DISPLAYS
VOLUME CONTROLS
TRIGGERS
LOCK OPTIONS
REAR PANEL CONFIG
The REAR PANEL CONFIG menu can be used to configure AUDIO
INPUT pairs 1 to 8 on the rear panel. These inputs can be set up to
function as eight stereo analog input pairs, or as five stereo analog
input pairs and one 5.1-channel analog input.
8 STEREO INPUTS
8 STEREO INPUTS is the default setting for REAR PANEL CONFIG.
When set to 8 STEREO INPUTS, the AUDIO INPUTS are configured
as eight stereo analog input pairs. Pairs 6, 7, and 8 are not
available as a 5.1-channel analog input. Input types that are
assigned to the 5.1-channel analog input will be reassigned to
stereo input Pair 6.
5 STEREO & 5.1 ANLG
When set to 5 STEREO & 5.1 ANLG, the AUDIO INPUTS are
configured as five stereo analog input pairs and one 5.1-channel
analog input. The 5.1-channel analog input consists of AUDIO
INPUT pairs 6, 7, and 8. Pair 6 becomes the front left and right
(L)/(R) inputs. Pair 7 becomes the center (C) and subwoofer (SUB)
inputs. And Pair 8 becomes the surround left and right (LS)/(RS)
inputs. Input types that are assigned to stereo analog input pairs
6, 7, and 8 will be reassigned to the 5.1-channel analog input.
When selected for the Main Zone, these input signals are sent to
the corresponding outputs. However, neither Zone 2 nor the
Record Zone provide multi-channel outputs. If the 5.1-channel
analog input is selected for Zone 2 or the Record Zone, only the
front left and right (L)/(R) inputs will be available.
SETUP
REAR PANEL CONFIG
5 STEREO & 5.1 ANLG
SETUP REAR PANEL CONFIG
8 STEREO INPUTS
Note:
If 5 STEREO & 5.1 ANLG is selected on the REAR PANEL CONFIG
menu, the unit will automatically select the 5.1 BYPASS listening
mode if the following conditions are also met:
• The ANALOG IN parameter on the INPUT SETUP menu is
set to 5.1 ANALOG (see page 3-6).
• The INPUT SELECT parameter on the MAIN ADV menu is set
to either AUTO or ANALOG (see page 3-13). When set to
AUTO, no digital input types can be present.
• The ANALOG BYPASS parameter on the MAIN ADV menu
is set to ON (see page 3-13).
MAIN MENU
MODE ADJUST
AUDIO CONTROLS
SETUP