Filter
Top Products
The MENU arrows navigate through all menus when the MAIN
command bank is active (see page 2-8 for more information about
command banks). Press the up and down MENU arrows to scroll
through menu items. A scroll bar will appear on the right side of
the screen when these items exceed the on-screen margins. Press
the right MENU arrow to select the highlighted item. Press the left
MENU arrow to exit the current menu.
TWO-LINE STATUS
The two-line status (pictured at the right)
appears on the on-screen display whenever
the unit receives a command or whenever
the input type changes, unless the STATUS parameter on the
ON-SCREEN DISPLAY menu is set to OFF (see page 3-31). Pressing
the STAT button on the remote control will also display the two-line
status. The two-line status that appears depends on which remote
control command bank is active (see page 2-8).
The two-line status shows the current input name (top-left); the
current listening mode name (bottom-left); the current input type
(top-center); and the current volume level (right).
RESTORING FACTORY-DEFAULT SETTINGS
The procedure below outlines the process to restore factory-default
settings. Before performing these steps, record custom settings on
the installation worksheet (see page A-12). All parameters will be
reset to their factory-default value. This procedure should be
performed before setup begins.
To restore factory-default settings:
1. Record user-defined settings on the installation worksheet
(see page A-12).
2. If the unit is on, place it into standby by pressing the
(standby) button on the remote control. If the unit is in
standby, skip ahead to Step 3.
3. Power the unit on by pressing the@@@((standby) button
on the remote control.
4. Quickly press and hold the MUTE button on the remote
control until the following hidden menu appears:
The MUTE button must be pressed within 3s of powering
the unit on. If the message “MUTE ON” appears in the top-
left corner of the screen when the MUTE button is pressed,
too much time has passed. Begin again with Step 2.
5. Use the up and down MENU arrows to highlight RESTORE
DEFAULTS, then press the right MENU arrow to restore
factory-default settings. (Selecting the EXIT option with the
right MENU arrow will cancel the restoration of factory-
default settings.)
6. The message “FACTORY SETTINGS HAVE BEEN
RESTORED” will appear on the screen. Press any front
panel or remote control button to restart the unit.
FACTORY SETTINGS
EXIT
RESTORE DEFAULTS
DVD1 DD D VOL
5.1 L7 FILM -30dB
1-5
Getting Started
SDP-40