Filter
Top Products
Saving and recalling the system settings (System Memory)
98 En
■ Saved parameters for the main zone
The groups of the system parameters indicated in bold are the
groups that is saved in the initial setting.
* The playing status of the network/USB sources (selected radio station, etc.) is also
saved.
■ Saved parameters for Zone 2, Zone 3, or Zone 4
* The playing status of the network/USB sources (selected radio station,
etc.) is also saved.
■ Loading by the 7SYSTEM MEMORY buttons
You can recall the system settings stored in “Memory1” to
“Memory4” by pressing the corresponding 7SYSTEM MEMORY
buttons.
y
To recall the system settings for Zone 2, Zone 3, or Zone 4, press HZONE on the
remote control repeatedly to select the operation zone setting of the remote control in
advance. You can recall the system settings for the selected zone only when the zone is
turned on.
1 Press one of the 7SYSTEM MEMORY buttons on
the remote control to select the desired memory
number.
“MEMORY 1 LOAD” (example) appears in the front panel
display.
y
“EMPTY” appears in the menu screen if no system settings are stored in the
selected memory number.
2 Press the selected 7SYSTEM MEMORY button
once more to confirm the selection.
This unit loads the settings stored in the selected memory
number.
■ Loading by the GUI menu operation
1 Press
I
MENU on the remote control.
The top menu appears in the video monitor.
2 Press 9k / n repeatedly to select “System Memory”
and then press 9h.
The “System Memory” menu appears in the video monitor.
3 Press 9k / n repeatedly to select the desired zone
and then press 9h.
In the following example, you select “Main” (main zone). The
list of the memory number appears in the video monitor.
Group Parameters Page
Input/HDMI
Out
*
Audio Select
82
Decoder Mode
82
Input source 50
HDMI OUT SEL
—
Audio Stereo/Surround
77
Pure Direct on/off 61
EXTD SUR. setting 72
Adaptive DRC
86
Adaptive DSP Lvl
86
LFE Level
86
Dynamic Range
87
Tone Control
88
Pure Direct
89
CINEMA DSP HD³ ON/OFF 60
Volume Volume level
50
SP Config S-Wave Control
87
Parametric EQ
87
THX Set
83
Speaker Set
84
Speaker Distance
85
Speaker Level
86
Speaker B
91
Information (Auto Setup)
45
Setup Menu (Auto Setup)
44
Selected front speaker set (A and/or B)
51
Video Conversion
89
HDMI Processing
90
Component I/P
90
HDMI Resolution
90
HDMI Aspect
90
Short Message
90
On Screen
90
Position
90
Wall Paper
91
Option Lipsync
88
Front Panel Disp.
93
Support Audio
94
Note
Parameter Descriptions Page
Input
Input source *
117
Vo l u m e
Volume level
117
Tone Control
Tone control settings
117
Note
Loading the stored system settings
• Before performing the following operations, set the operation mode selector on
the remote control to
F
AMP.
• This unit overwrites the stored settings to the current settings of this unit. If you
do not want to erase the current settings, save the current settings to any System
Memory number in advance.
Main Load
Main Save
Main Rename
Memory1
Memory2
Memory3