Filter
Top Products
Remote control features
110 En
Use the supplied simplified remote control to make basic controls of this unit.
When you select “NET/USB” as the input source, this unit activates the last selected sub input source (see page 67).
■ Setting the controlling zone of the simplified
remote control
Use this feature to set the controlling zone (see page 116) and
remote control ID (see page 119) of the simplified remote control.
Setting the remote control ID
Press and hold b on the simplified remote control and then 1 or
2 for 3 seconds to select the desired remote control ID.
• ID1: Press and hold b and 1.
• ID2: Press and hold b and 2.
Setting the controlling zone
Press and hold a on the simplified remote control and then 1, 2,
3, or 4 to select the desired zone.
• Main zone: Press and hold a and then press 1.
• Zone 2: Press and hold a and 2.
• Zone 3: Press and hold a and 3.
• Zone 4: Press and hold a and 4.
■ Replacing the battery in the simplified remote
control
Change the battery when the operation range of the simplified
remote control decreases.
• Insert the battery according to the polarity markings (+ and –).
• If the batteries run out, immediately remove them from the simplified
remote control to prevent an explosion or acid leak.
• If a battery starts leaking, dispose of it immediately. Be careful not to let
the leaking battery acid touch your skin or clothing.
• Before inserting new batteries, wipe the compartment clean.
• Dispose of batteries according to your regional regulations.
Simplified remote control
Note
POWER
STANDBY
INPUT
SYSTEM MEMORY
4132
INT SOURCE VOLUME
MUTE
PRESET
STANDBY
Sets the selected zone to the
standby mode.
☞ P. 39
SYSTEM MEMORY
Save or recall the system settings.
☞ P. 96
INPUTl / h
Select the input source.
☞ P. 50
PRESET +/–
Recall the preset network/USB
contents.
☞ P. 70
s(stop) / p(play) /
b(skip backward) /
a(skip forward)
Control playback of the iPod or
Network/USB contents.
☞ P. 64, 67
POWER
Turn on the power.
☞ P. 39
VOLUME +/–
Adjust the volume level.
☞ P. 50
MUTE
Mutes the audio output.
☞ P. 52
Remove the insulation sheet before using the remote
control.
Notes
Use a straight
pin to remove
the cover.
Replace the battery
with a new CR2025
battery.
Close the cover.