Filter
Top Products
Using multi-zone configuration
117 En
Advanced
Operation
3 Perform the operations in the selected zone.
For further operations, refer to the following pages:
y
To turn off the desired zone, press KZONE 2, KZONE 3, or KZONE 4 again.
Remote control operations
1 Press
H
ZONE repeatedly to select the zone you
want to control.
“MAIN”, “ZONE 2”, “ZONE 3”, or “ZONE 4” indicator
appears in the display window (4) on the remote control.
2 Press EPOWER to turn on the selected zone.
3 Perform the operations in the selected zone.
For further operations, refer to the following pages:
y
To turn off the desired zone, press DSTANDBY.
■ Selecting the input source Zone 2, Zone 3, or
Zone 4
Rotate the
D
INPUT selector on the front panel (or set
the operation mode selector to
F
AMP and then press
one of the input selector buttons (
3
)) to select the input
source of the selected zone.
• Select “DOCK” as the input source to use the iPod features in
the selected zone. For details about the iPod operations, see
“Using iPod™” on page 64.
• Select “NET/USB” as the input source to use the network/USB
operations features in the selected zone. For details about the
iPod operations, see “Using Network/USB features” on page 66.
• The selected input sources are shared across all zones.
• If you set the recording source other than “SOURCE” (see page 62), the input source
of Zone 2 is fixed to the source you set as the recording source.
■ Adjusting the volume level of Zone 2, Zone 3, or
Zone 4
Rotate EVOLUME on the front panel (or press
JVOLUME +/–) to adjust the volume level of the
selected zone.
y
Press
L
MUTE on the remote control to mute the sound output to the selected zone.
When you use the external amplifiers in Zone 2 or Zone 3,
J
VOLUME +/– can be
used only when “Zone2 Volume”, “Zone3 Volume”, or “Zone4 Volume” is set to
“Variable” in “Zone2 Set”, “Zone3 Set”, or “Zone4 Set” (see page 91).
■ Setting the sleep timer for Zone 2, Zone 3, or
Zone 4
Use this feature to turn off the desired zone to the standby mode
after a contain amount of time.
Set the operation mode selector to FAMP on the remote
control and then press CSLEEP repeatedly to set the
amount of time.
Each time you press CSLEEP, the sleep timer setting changes as
shown below.
Descriptions
Page
“Selecting the input source Zone 2, Zone 3, or Zone 4” 117
“Adjusting the volume level of Zone 2, Zone 3, or Zone 4” 117
“Adjusting the tonal quality of Zone 2, Zone 3, or Zone 4” 118
Descriptions
Page
“Selecting the input source Zone 2, Zone 3, or Zone 4” 117
“Adjusting the volume level of Zone 2, Zone 3, or Zone 4” 117
“Adjusting the tonal quality of Zone 2, Zone 3, or Zone 4” 118
MAIN
ZONE 2 ZONE 3
ZONE 4
(Zone 2) (Zone 3) (Zone 4)
(Main zone)
Operate the following operations after activating the Zone 2, Zone 3, or Zone 4
operation mode.
Notes
Note
120min. 90min.
60min.30min.OFF