Filter
Top Products
73
Additional Information
Play does not start.
• Replace the MD.
• Insert the MD and leave the system turned on
for a few hours until the moisture evaporates.
• Press MD H to start play.
The sound skips.
• Replace the MD.
• Try moving the system to a place without
vibration (e.g., on top of a stable stand).
• Try moving the speakers away from the
system, or placing them on separate stands.
When you listen to a track with bass sounds at
high volume, the speaker vibration may cause
the sound to skip.
• Insert the disc and wait for 10 to 20 minutes
with the system turned on.
Play does not start from the first track.
• Press PLAY MODE repeatedly in MD stop
mode until “PROGRAM” or “SHUFFLE”
disappears to return to normal play.
“Over” appears.
• Press and hold m or turn MD JOG to return
to the desired playing position.
“OVER” lights during recording.
• Set the volume of the connected component
lower.
Recording or editing was done, but the
TOC is not updated.
• MD recording and editing contents are
recorded to the MD when the MD is removed,
so make sure you remove the MD after
recording or editing (see pages 27 and 40).
Recording is not possible.
• Remove the MD and slide the tab to close the
slot (see page 27).
• Connect the optional A/V component
properly (see page 66).
• Switch to another sound source.
• Replace the MD with a recordable MD, or use
the Erase Function to erase unnecessary tracks
(see page 43).
• Start recording over from the beginning.
The sound from an MD you recorded is
too low (or too high).
• Readjust the recording level (see page 37).
Tuner
There is severe hum or noise (“TUNED” or
“STEREO” flashes in the display).
• Adjust the aerial.
• The signal strength is too weak. Connect the
external aerial.
A stereo FM programme cannot be
received in stereo.
• Press STEREO/MONO so that “STEREO”
appears.
If the system still does not
operate properly after
performing the above measures,
reset the system as follows:
1 Unplug the power cord.
2 Plug the power cord back in.
3 Press CLEAR and CD s at the same time.
4 Press ?/1 to turn on the power.
The system is reset to the factory settings. All the
settings you made such as the preset stations,
clock and timer are cleared and must be set again.
If the system still does not operate properly, press
GROOVE and ?/1 at the same time in step 3
above.