Filter
Top Products
The MD Deck
— Editing
53
Fade-in and Fade-out
Recording
1 Press MD to switch the function to MD.
2 Press S.F EDIT.
“S.F Edit” appears in the display.
3 Turn MD JOG until “Fade In?” or
“Fade Out?” appears, then press
ENTER/YES.
4 Turn MD JOG until the track number
you want to change the recording level
appears, then press ENTER/YES.
“Time 5.0s” appears in the display.
5 While monitoring the sound, turn MD
JOG to change the Fade-in or Fade-out
recording time.
The system plays the portion that will be
recorded over using Fade-in or Fade-out
Recording. You can set the time at any value
between 1.0 second and 15.0 seconds, in 0.1
second increments. You cannot set the time
longer than the track.
6 Press ENTER/YES.
“S.F Edit OK?” appears in the display.
7 Press ENTER/YES.
The deck starts recording over the existing
track. “S.F Edit: ** %” appears while the
track is being recorded. An amount of time
that is roughly equal to or longer than the
playback time of the track is required when
recording over the track. When the recording
finishes, “Complete!” appears in the display
for a few seconds.
To cancel the operation
Press MENU/NO in steps 1 to 6. If you press
ENTER/YES in step 7 and recording starts, you
cannot interrupt the operation.
Notes
• Do not disconnect the mains lead or move the
system while recording is in progress. This may
damage the recording data preventing recording
from being performed properly.
• You cannot change the recorded level of a track
recorded in LP2 or LP4 mode.
• Do not use an MD that is damaged or dirty. This
may prevent recording data from being recorded
properly.
• Repeatedly changing the recording level results in
poor sound quality.
• The recording level will not return to the exact
original level once the recording level has been
changed even if it returned to the original level.
• The recording level cannot be changed while the
timer is activated.
• You cannot undo the S.F Edit Function even if you
use the Undo Function.