Filter
Top Products
14
Recording a CD on an MD at high
speed (continued)
Notes
• You cannot record over existing material during
High-Speed CD-MD Synchro Recording. The MD
deck automatically starts recording from the end of
the existing material.
• Make sure that the remaining recordable time on the
MD is longer than the playing time of the CD,
especially if you want to record all the tracks on the
CD.
• You cannot pause recording during High-Speed
CD-MD Synchro Recording. If you pause or stop
recording, a track that was recorded only partially is
not recorded to the MD.
• If the play mode is set to the Repeat or Shuffle Play,
it automatically switches to normal play at step 3.
• The following items are either inoperative or cannot
be used during High-Speed CD-MD Synchro-
Recording:
— The Auto Cut Function
— Recorded signal monitoring
• With the following kinds of CDs, you may
experience a reading failure or noise when recorded
to an MD:
— CDs with adhesive labels attached to them
— Irregularly shaped CDs (for example, heart- or
star- shaped)
— CDs with printed text concentrated on one side
only
— Old CDs
— Scratched CDs
— Dirty CDs
— Warped CDs
• If the following occurs during CD playback or
recording, a reading error may occur or noise may
be produced in the recorded results:
— The CD tray or other part of the system is
bumped.
— The system is placed on an uneven or soft
surface.
— The system is located near a speaker, door, or
other source of vibration.
• If the above reading errors occur, a extra soundless
track may be created. You can erase these extra
tracks using the edit function of the MD deck (see
page 43).
To stop recording
Press CD s or MD s.
If “Retry” flashes in the display
after you press MD S in step 4
A reading failure has occurred, and the MD deck
is trying to read the data again.
• If the retry was successful, the MD deck
continues with High-Speed CD-MD Synchro
Recording. In this case, “×2” lights up in the
display.
• If the condition of the inserted CD or the MD
deck is poor, and retry fails, High-Speed CD-
MD Synchro Recording is disabled. In this
case, “×1” flashes in the display and the MD
deck automatically starts recording in normal
CD-MD Synchro Recording. Note that
monitoring of the recorded signal is not
possible when this occurs.