Filter
Top Products
42
3 Press CHARACTER to select the
desired type of character.
Each time you press the button, the display
changes as follows:
(Blank space) t A (Upper cases) t a
(Lower cases) t 0 (Number) t ’
(Symbols) t (Blank space) t
…
4 Turn MD JOG to select the desired
character.
To enter a blank space
Press MD M without turning MD JOG.
To enter a symbol
You can use the following 24 symbols.
’ – / , . ( ) : ! ? & + < > _ = ” ; # $ % @ `
5 Press MD M.
The character you selected in step 4 stops
flashing and the cursor shifts to the right.
Cursor
6 Repeat steps 3 to 5 to complete the
entire title.
If you make a mistake
Press MD m or M until the character you
want to change flashes, then repeat steps 3 to
5.
To erase a character
Press CLEAR while the character is flashing.
You cannot insert characters.
7 Press ENTER/YES to complete the
labelling procedure.
The titles you labelled appear sequentially,
and then the original display appears.
To cancel labelling
Press MENU/NO.
Notes
• You can label a track title during play. The
playback repeats until you finish labelling.
• If the MD is record protected, “C11” and
“Protected” appear alternately and the MD cannot
be recorded. Remove the MD, then slide the record
protection tab to the closed position (see page 27).
Copying a disc or track title
You can copy a labelled disc or track title to use it
as a title of another track or the disc title within a
disc.
1 Press MENU/NO in stop mode.
2 Turn MD JOG until “Name?” appears, then
press ENTER/YES.
3 Turn MD JOG until “Nm Copy?” appears, then
press ENTER/YES.
4 Turn MD JOG to select “Disc” (when copying
the disc title) or the track number with the title
you want to copy, then press ENTER/YES.
5 Turn MD JOG to select the copy destination
track number or “Disc” (when copying as the
disc title), then press ENTER/YES.
When “Overwrite??” appears
The copy destination already has a disc or track
title. To continue and copy the title, press
ENTER/YES.
To cancel copying
Press MENU/NO.
Labelling an MD (continued)