Filter
Top Products
52
Changing the recorded
level after recording
— S.F Edit Function
You can change the volume of recorded tracks
using S.F (Scale Factor) Edit. The original track is
recorded over at the new recording level. When
changing the recording level, you can select Fade
-in Recording to gradually increase the signal
level at the start of recording, or Fade-out
Recording to gradually decrease the signal level at
the end of the recording.
2
1
3
4
5
3,4,6,71
2 3,4,5
?/1 (Power)
Changing the overall
recording level
1 Press MD to switch the function to MD.
2 Press S.F EDIT.
“S.F Edit” appears in the display.
3 Turn MD JOG until “Tr Level?”
appears, then press ENTER/YES.
4 Turn MD JOG until the track number
you want to change the recording level
appears, then press ENTER/YES.
“Level 0dB” appears in the display.
5 While monitoring the sound, turn MD
JOG to change the recorded level
without turning on “OVER” on the peak
level meters.
You can set the level at any value between
–12 dB and +12 dB, in 2 dB increments.
6 Press ENTER/YES.
“S.F Edit OK?” appears in the display.
7 Press ENTER/YES.
The deck starts recording over the existing
track. “S.F Edit: ** %” appears while the
track is being recorded. An amount of time
that is roughly equal to or longer than the
playback time of the track is required when
recording over the track. When the recording
finishes, “Complete!” appears in the display
for a few seconds.