Filter
Top Products
51
Additional Information
Tuner
Severe hum or noise/stations cannot be
received.
• Set the proper band and frequency (see page 34).
• Connect the aerial properly (see page 6).
• Find a place and an orientation that provide good
reception, then set up the aerial again. If you
cannot obtain good reception, we recommend
you connect a commercially available external
aerial.
• The supplied FM lead aerial receives signals
along its entire length, so make sure you extend
it fully.
• Locate the aerials as far away from the speaker
cords as possible.
• Consult your nearest Sony dealer if the supplied
AM aerial has come off the plastic stand.
• Try turning off surrounding electrical
equipments.
A stereo FM programme cannot be received in
stereo.
• Press STEREO/MONO until “STEREO” appears
in the display.
• See “Severe hum or noise/stations cannot be
received.”, and check the aerial condition.
Cyclical static noise is heard while recording on
an MD.
• Adjust the aerial orientation and position until
the noise stops.
If the system still does not operate
properly after performing the above
measures, reset the system as
follows:
1 Disconnect the mains lead.
2 Reconnect the mains lead.
3 Press ?/1 to turn on the system.
4 Press x, DISPLAY and CD 1 at the same
time.
5 Press ?/1 to turn on the system.
The system is reset to the factory settings. All
the settings you made such as the preset
stations, clock, timer and CD disc titles are
cleared and must be set again.