Filter
Top Products
34
Tuner
Presetting radio stations
You can preset 20 stations for FM and 10
stations for AM.
1 Press TUNER/BAND repeatedly to
select “FM” or “AM”.
Pressing TUNER/BAND turns on the
system.
2 Press and hold m or M until “AUTO”
appears.
3 Press m or M.
The frequency indication changes and the
scanning stops when the system tunes in a
station. “TUNED” and “STEREO” (for a
stereo programme) appear.
4 Press MENU/NO.
5 Turn ./> (or press . or > on
the remote) until “Memory?” appears,
then press ENTER/YES.
A preset number appears in the display. The
stations are stored from preset number 1.
Preset number
6 Press ENTER/YES.
“Complete!” appears, and then the station is
stored.
7 Repeat steps 1 to 6 to store other
stations.
To stop scanning
Press m or M.
To tune in a station with a weak
signal
Press m or M in step 2. “MANUAL”
appears. Then press m or M repeatedly to
tune in the station manually.
To set another station to an existing
preset number
Start over from step 1. After step 5, turn ./
> (or press . or > on the remote) to
select the preset number you want to store the
other station.
To change the AM tuning interval
(except for the European model)
The AM tuning interval is factory-set to 9 kHz
(10 kHz in some areas). To change the AM
tuning interval, tune in any AM station first,
then turn off the system. While holding
STEREO/MONO, turn the system back on.
When you change the interval, all the AM
preset stations are erased. To reset the interval,
repeat the same procedure.
Tip
The preset stations are retained for about a day even if
you disconnect the mains lead or if a power failure
occurs.