Filter
Top Products
42
7 Turn ./> (or press . or > on
the remote) to select the desired sound
source.
The indication changes as follows:
t
TUNER
y
CD PLAY
T
t
TAPE PLAY
y
MD PLAY
T
8 Press ENTER/YES.
The start time, the stop time, and the sound
source appear in turn, before the original
display returns.
9 Press ?/1 to turn off the system.
To Do this
Check the setting Press CLOCK/TIMER
SELECT on the remote, then
turn ./> (or press
. or > on the remote)
until “DAILY SELECT?”
appears. Then, press ENTER/
YES.
Change the setting Start over from step 1.
Cancel the timer Press CLOCK/TIMER
SELECT on the remote, then
turn ./> (or press
. or > on the remote)
until “TIMER OFF” appears.
Then, press ENTER/YES.
Notes
• If the system is on about 30 seconds before the
preset time, the Daily Timer will not be activated.
• Do not operate the system from the time the system
turns on until the play starts (about 30 seconds
before the preset time).
Waking up to music
— Daily Timer
You can wake up to music at a preset time.
Make sure you have set the clock (see “Setting
the time” on page 8).
1 Prepare the sound source you want to
play.
• CD: Place a CD. To start from a
specific track, make a programme (see
“Programming CD tracks” on page 11).
• MD: Insert an MD. To start from a
specific track, make a programme (see
“Programming MD tracks” on page 15).
• Tape: Insert a tape.
• Radio: Tune in a station (see
“Listening to the radio” on page 35).
2 Turn VOLUME (or press VOL+ or – on
the remote) to adjust the volume.
3 Press CLOCK/TIMER SET on the
remote.
“DAILY SET ?” appears.
4 Press ENTER/YES.
“ON” appears and the hour indication
flashes.
5 Set the time to start playing.
Turn ./> (or press . or > on
the remote) to set the hour, then press
ENTER/YES.
The minute indication flashes.
Turn ./> (or press . or > on
the remote) to set the minute, then press
ENTER/YES.
6 Set the time to stop playing following
the procedure in step 5.