Filter
Top Products
39
Tape – Recording
Recording an MD on a
tape
— MD-TAPE Synchro Recording
1 Load a blank tape.
2 Load an MD.
3 Press SYNCHRO MODE repeatedly until
“MDtTAPE SYNC?” appears.
4 Press ENTER/START.
The tape deck stands by for recording and
the MD deck pauses for play.
5 Press ENTER/START.
MD playing and tape recording start.
To stop recording
Press x.
Tips
• When you record on both sides, be sure to start
from the top side. If you start from the bottom side,
recording stops at the end of the bottom side.
• If you select both sides recording and the tape
reaches the end of the top side part-way through a
track, the entire track is recorded again from the
beginning of the bottom side.
• You can record only your favourite MD tracks with
Programme Play. After step 2, follow the same
procedures as step 1 to 5 in “Programming MD
tracks” on page 15. Then, go to step 3.
Note
If the tape becomes full during recording, the MD
deck and the tape deck stop automatically.
Recording on a tape
manually
— Manual Recording
You can record just the portions you like from
a CD or an MD on a tape. You can also record
a radio programme.
The recording level is automatically adjusted.
1 Load a blank tape.
2 Press FUNCTION repeatedly to select
the desired source to record.
3 Press TAPE REC PAUSE/START.
The tape deck stands by for recording.
When you want to record on the bottom
side, press TAPE n N.
4 Press PLAY MODE/DIRECTION
repeatedly until g appears to record
on one side or h (or j) to record on
both sides.
5 Press TAPE REC PAUSE/START and
then start playing the desired source to
record.
Tips
• When you record on both sides, be sure to start
from the top side. If you start from the bottom side,
recording stops at the end of the bottom side.
• If you select both sides recording and the tape
reaches the end of the top side part-way through a
track, the entire track is recorded again from the
beginning of the bottom side.