Filter
Top Products
7
Getting Started
AM loop aerial
Extend the FM lead aerial
horizontally
Jack type B
FM75
COAXIAL
AM
3 For models with a voltage selector, set
VOLTAGE SELECTOR to the local
mains voltage.
VOLTAGE SELECTOR
230-
240V
220V
120V
4 Connect the mains lead to the mains.
The demonstration appears in the display.
If the plug of the mains lead does not fit
your mains, attach the supplied adaptor on
to the plug (for models with a plug adaptor).
To turn on the system, press ?/1 .
The demonstration mode
The demonstration mode appears in the display
when you connect the mains lead to the mains.
When you press ?/1, the system turns on and
the demonstration automatically ends. The
demonstration is deactivated when you set the
time.
To activate/deactivate the demonstration again,
press DISPLAY while the system is off.
To adjust the brightness of the
display back light
1 Press DIMMER while the system is on.
2 Turn ./> (or press . or > on
the remote) to adjust the back light
brightness.
You can adjust the back light brightness in
11 steps from –5 to +5.
When carrying this system
Perform the following procedure to protect the
CD mechanism.
1 Make sure that all discs are removed from
the system.
2 Press FUNCTION while holding down CD 1
and then press ?/1 until “LOCK” appears.
3 Disconnect the mains lead.
Inserting two R6 (size AA)
batteries into the remote
E
e
e
E
Tip
When the remote no longer operates the system,
replace both batteries with new ones.
Note
If you do not use the remote for a long period of time,
remove the batteries to avoid possible damage from
battery leakage.