Filter
Top Products
18
Recording a CD on an MD (continued)
Recording a tape on an
MD
— TAPE-MD Synchro Recording
You can make an analogue recording of a tape
on an MD.
1 Load a recordable MD.
2 Insert a tape.
3 Press SYNCHRO MODE repeatedly until
“TAPEtMD SYNC?” appears.
4 Press ENTER/START.
The MD deck stands by for recording and
the tape deck pauses for play.
Tape playback side
>>> appears for the top side, and <<< for
the bottom side. To play the side not
indicated, press x and remove the cassette
to reverse the tape side, then perform steps
3 and 4 again.
5 Press ENTER/START again.
Recording starts.
To stop recording
Press x.
Note
If the MD becomes full during recording, the tape
deck and the MD deck stop automatically.
If “Retry” flashes in the display after
you press ENTER/START in step 7
A reading failure has occurred, and the system
is trying to read the data again.
• If the retry was successful, the system
continues with High-Speed CD-MD Synchro
Recording.
• If the condition of the inserted CD or the
system is poor, and retry fails, High-Speed
CD-MD Synchro Recording is disabled. In
this case, “×1” flashes in the display and the
MD deck automatically starts recording.
Note that monitoring of the recorded signal
is not possible when this occurs.
To record on an MD for a long time
(MDLP recording)
See “Recording tips” on page 20.
To stop recording
Press x.
Tips
• Depending on the disc, CD TEXT information may
also be recorded (except when you record on an
MD and a tape at the same time). If “CD-TEXT”
flashes during recording, see “Labelling an MD” on
page 25.
• You can record only your favourite CD tracks with
Programme Play. After step 2, follow the same
procedures as step 1 to 6 in “Programming CD
tracks” on page 11. Then, go to step 5.
Notes
• You cannot pause recording during High-Speed
CD-MD Synchro Recording.
• If the play mode is set to Repeat Play or Shuffle
Play, it automatically switches to normal play at
step 6.
• The following items are either inoperative or cannot
be used during High-Speed CD-MD Synchro
Recording:
— The Auto Cut Function
— The recording level specified in the Setup menu
• If the MD becomes full during recording, the CD
player and the MD deck stop automatically.