Filter
Top Products
11
CD
Programming CD tracks
— Programme Play
You can make a programme of up to 25 tracks.
1 Press FUNCTION repeatedly to switch
the function to CD.
2 Press PLAY MODE/DIRECTION
repeatedly until “PGM” appears.
3 Press CD 1 – 3 to select a CD.
To programme all the tracks on a CD at
once, proceed to step 5 with “AL”
displayed.
4 Turn ./> (or press . or > on
the remote) until the desired track
number appears.
Playing time of the selected track
Selected CD and track number
5 Press ENTER/YES.
The track is programmed.
“STEP” appears, followed by the number of
the track in the programmed sequence. The
number of the last programmed track or
“CD1-AL” appears, followed by the total
playing time of the programme.
Total playing time
Last programmed track number
6 To programme additional tracks, repeat
steps 3 to 5.
7 Press CD NX (or N on the remote).
To Do this
Press PLAY MODE/DIRECTION
repeatedly until “PGM” and
“SHUFFLE” disappear.
Press CHECK on the remote
repeatedly in stop mode. After the
last track, “Check End” appears.
Press CLEAR on the remote in
stop mode.
Press CHECK on the remote
repeatedly in stop mode until the
number of the track to be erased
lights up, then press CLEAR.
Perform steps 3 to 5.
Tips
• The programme you made remains after
Programme Play finishes. To play the same
programme again, press CD NX.
•“- -.- -” appears when the total CD programme time
exceeds 100 minutes, or when you select a CD track
whose number is 21 or over.
Cancel
Programme Play
Check the
programme
Clear a track
from the end
Clear a specific
track
Add a track to
the programme
in stop mode