Filter
Top Products
17
MD – Play/MD – Recording
Note on MD track numbers
On an MD, the track numbers (track sequence), track
start and end point information, etc., are recorded in
the TOC*
2
area independent of the sound information.
You can edit recorded tracks quickly by modifying
the TOC information.
*
2
TOC: Table Of Contents
After recording
Press Z to remove the MD or press ?/1
(power) to turn off the system.
“TOC” lights up, or either “TOC” or
“STANDBY” starts flashing. The TOC is
updated and recording is completed.
Before pulling out the mains lead
MD recording is completed when the MD
Table of Contents (TOC) is updated. The TOC
is updated when you eject the MD or press ?/1
to turn off the system. Do not pull out the
mains lead before updating the TOC (while
“TOC” is lit) or while updating the TOC (while
“TOC” or “STANDBY” is flashing) to ensure a
complete recording.
Protecting a recorded MD
To protect a recorded MD, slide the tab on the
side of the MD to open the slot. In this position,
the MD cannot be recorded. To record on the
MD, slide the tab to close the slot.
Recording a CD on an MD
— CD-MD Normal-Speed Synchro
Recording/CD-MD High-Speed
Synchro Recording
In addition to normal-speed recording, you can
also record at high speed (approximately twice
the normal speed).
1 Load a recordable MD.
2 Load a CD you want to record.
3 Press FUNCTION repeatedly to switch
the function to CD.
4 Press PLAY MODE/DIRECTION
repeatedly until “1 DISC” appears in the
display.
5 Press SYNCHRO MODE repeatedly until
“CDtMD SYNC?” appears.
To record at high speed (CD-MD High-
Speed Synchro Recording), press
SYNCHRO MODE repeatedly until
“HISPEED SYNC?” appears.
6 Press ENTER/START.
The MD deck stands by for recording and
the CD player pauses for play.
7 Press ENTER/START again.
Recording starts. You cannot monitor the
recorded signal during high-speed
recording.
To record on an MD and a tape at the
same time
See “Recording a CD on a tape” on page 38.
If you stop recording or the MD runs
out of recording time during high-
speed recording
The partial high-speed recorded track is not
recorded on the MD. Record the track again.
continued
Tab
Slide the tab