Filter
Top Products
150
Menu List
Appendix
304
VAR SPEED RANGE
FOR
SYNCHRONIZATION
[-1 to +2]
–1.15 to +2.45
Specifies the variable tape speed range when the variable
speed playback is executed by a remote control unit
connected to the REMOTE 1-IN(9P) connector.
–1 to +2: –1 to +2 times normal tape speed
–1.15 to +2.45: –1.15 to +2.45 times normal tape speed
Note
When an editing control unit such as BVE-9100 is
connected for DT editing, select “–1.15 to +2.45”.
305 EDIT FIELD select [1F]
2F
1F/2F
Selects the start timing for editing when performing tape
editing.
1F: Start editing from field 1 and end on field 2.
2F: Start editing from field 2 and end on field 1.
1F/2F: Following received timing commands.
Note
When the system frequency of this unit is PsF mode, the
unit always operates with the 1F setting.
306 SYNCHRONIZE [accurate]
rough
off
When this unit is used as a controller for editing control of
another VTR connected through a 9-pin remote cable, this
selects whether or not to carry out phase synchronization
of the two VTRs, and also the editing accuracy when
carrying out synchronization.
accurate: Editing is carried out with an accuracy of ±0
frames.
rough: Editing is carried out with an accuracy of ±1 frame.
off: Synchronization is not carried out.
311 EDIT PRESET
REPLACE MODE
SELECT
[normal]
parallel
reverse
stereo
normal: Assigns edit preset command channels 1 to 8, to
track channels 1 to 8.
parallel: Assigns edit preset command channels 1 to 4, to
channel pairs 1/5 to 4/8.
reverse: Assigns edit preset command channels 1 to 4 to
channels 5 to 8, and channels 5 to 8 to channels 1 to 4.
stereo: Assigns edit preset command channels 1 to 4 to
track channel pairs 1/2 to 7/8.
312 ANALOG AUDIO
EDIT PRESET
REPLACE
[no def]
ch1
ch2
ch1+2
When the edit presets for VTR channels 9 to 12 are
specified by an editor or remote controller, these are set on
or off according to the analog audio edit presets.
no def: Not set.
ch1: Follows analog channel 1 edit preset.
ch2: Follows analog channel 2 edit preset.
ch1+2: Follows the edit preset for analog channel 1 or
analog channel 2.
Sub items
ANALOG AUDIO
EDIT PRESET
REPLACE FOR
CH9
ANALOG AUDIO
EDIT PRESET
REPLACE FOR
CH10
ANALOG AUDIO
EDIT PRESET
REPLACE FOR
CH11
ANALOG AUDIO
EDIT PRESET
REPLACE FOR
CH12
Item number Item Setting Function