Sony 3-270-589-12 (1) CD Player User Manual


 
117
Troubleshooting
Appendix
When a disc is inserted
a) Displayed only when DISPLAY CONTROL >ALARM is set to “ON” or
“LIMITED”.
During front panel operations
Exchg batt! BATTERY NEEDS REPLACING. PLEASE
CONTACT SERVICE.
The NVRAM battery is exhausted. Contact your
Sony dealer.
Alarm message in time
data display section
Alarm message in monitor video
section
Description/action
Unknown FS! UNKNOWN FILE SYSTEM.
PLEASE FORMAT DISC OR EJECT.
Format the disc, or eject it (see page 44).
No FS! NO FILE SYSTEM.PLEASE EJECT DISC. Eject the disc.
ILL. Disc! IRREGULAR DISC IS USED.
USE PROFESSIONAL DISC.
Use a Professional Disc.
Salvage NG! CLIP SALVAGE WAS NOT COMPLETED. See “Handling of Discs When Recording Does Not
End Normally (Salvage Functions)” (page 45).
525/60 Clip
a)
IRREGULAR DISC IS USED. DVCAM
525/60 CLIP(S) EXIST.
Use another disc.
625/50 Clip
a)
IRREGULAR DISC IS USED. DVCAM
625/50 CLIP(S) EXIST.
4CHx16 Clip
a)
DISC HAS 4CHx16 BIT CLIP(S).
CHANGE RECORD FORMAT IN SETUP
MENU.
Change the setting of AUDIO CONTROL >REC
MODE in the setup menu (see page 101).
2CHx16 Clip
a)
DISC HAS 2CHx16 BIT CLIP(S).
CHANGE RECORD FORMAT IN SETUP
MENU.
Change the setting of AUDIO CONTROL >REC
MODE in the setup menu (see page 101).
No Support! FORMAT NOT SUPPORTED.
RECORDING AND PLAYBACK IS NOT
POSSIBLE.
A disc in an unsupported recording format is loaded.
Use a disc formatted in the MPEG HD or DVCAM
format.
ILL. Index! INDEX FILE ERROR.
PLEASE FORMAT DISC OR EJECT.
Format the disc, or eject it (see page 44).
FORMAT NG! AUTO FORMATTING WAS NOT
COMPLETED.
Eject the disc and insert it again, or insert another
disc.
DI read err CANNOT READ DISC
INFORMATION.PLEASE EJECT DISC.
Read err
DRV ADJ err CANNOT PERFORM AUTO DRIVE
ADJUSTMENT.
Alarm message in time
data display section
Alarm message in monitor video section Description/action
Alarm message in time
data display section
Alarm message in monitor video
section
Description/action
KEY INHI.!
a)
KEY INHIBIT MODE IS SELECTED. This appears when the KEY INH (SHIFT + DISPLAY)
button is on.
Turn the KEY INH button off.
REMOTE!
a)
REMOTE MODE IS SELECTED.
SET REMOTE/LOCAL/NETWORK
SWITCH TO LOCAL.
Set the remote control switch to “LOCAL”.
No Disc!
a)
NO DISC. Insert a disc and try again.