Filter
Top Products
37
DAB1 DISTRIBUTED AUDIO SYSTEM
NOTE: If the desired remote is not in the library,
try using a similar product remote from that man-
ufacturer. If that doesn’t work, see Adding IR
Codes to the User IR Library with the OptiLinQ
®
IR Learner, on page 39.
5. Select the device. Its commands will appear in the
small IR C
OMMAND WINDOW on the MACRO EDITOR
Screen (see
Figure 47
).
6. Select the desired command in the list and drag it to
the screen’s large M
ACRO window. (In this example,
the P
AUSE command — see
Figure 48
).
7. Click OK. The M
ACRO EDITOR screen will disappear.
There should now be a M
ACRO INDICATOR on the
Source 2 S
TOP button on the PRESS level.
8. Select the P
RESS-AND-HOLD button action level. The
M
ACRO INDICATOR should disappear from the Source
2 S
TOP button.
9. Right-click on the Source 2 S
TOP button.
10. Select the S
TOP
command from the IR Command
Window and drag it into the M
ACRO W
INDOW.
11. Click OK. M
ACRO EDITOR screen will disappear.
There should now be a M
ACRO INDICATOR on the
Source 2 S
TOP button on the PRESS-AND-HOLD level.
PROGRAMMED IR OUTPUT PORT SELECTOR
The default PROGRAMMED IR Port settings match the four
input sources: Programmed IR Port 1 = Source 1, etc.
You can use the P
ROGRAMMED IR OUTPUT PORT SELECTOR to
route the commands to other ports by selecting the
desired port
before
you drag the command into the
M
ACRO WINDOW.
In a system that has duplicate same-make/same-model source components, routing macro IR commands out of the C
OMMON
IR outputs will cause both of those components to respond to all macro commands for that component. If you want to retain
individual control of the components in macros you will need to connect IR emitters to two P
ROGRAMMED IR outputs and
create separate macro commands for each component, with those commands routed to individual P
ROGRAMMED IR outputs
for each component.
For example, in a system with duplicate CD changers connected to the DAB1’s S
OURCE 3 and SOURCE 4 inputs, connect the IR
emitter for the S
OURCE 3 CD player to PROGRAMMED IR OUTPUT #3 and the IR emitter for the SOURCE 4 CD player to PROGRAMMED
IR OUTPUT #4. Make sure that all of the IR macro commands for the SOURCE 3 CD player are routed to PROGRAMMED IR PORT
Select
IR Command
Programmed
IR Output Port
Selector
Drag Command
into Macro Window
Figure 48:
Dragging Commands into the M
ACRO WINDOW
IR Command
Window
Figure 47:
M
ACRO
EDITOR Screen with IR C
OMMAND LIBRARY Selected