Filter
Top Products
33
DAB1 DISTRIBUTED AUDIO SYSTEM
BBaassss,, TTrreebbllee aanndd BBaallaannccee::
These sliders set the bass level, treble level and left/right stereo balance in the zone.
NOTE: When the zone output’s Fixed/Variable button is in the Fixed position, the zone’s Default,
Maximum and Page Volume, Bass, Treble and Balance adjustments are disabled for the zone’s Line
Outputs. See page 13.
Setting Up Sources
The SOURCE
SETUP screen allows you to set up the four source inputs.
1. Open the D
EVICE menu and select SOURCE SETUP
. The SOURCE SETUP screen
(
Figure 43
) will appear.
2. Use the drop-down box to identify the particular type of component connected
to that set of source connections. If the list doesn’t include a suitable name you
can type one of your own into the box.
3. Use the V
OLUME OFFSET slider to adjust the input level of the source component. This
lets you balance the output levels of the different source components so they will
play at (or very close to) the same volume:
a) Play program material on all of the connected source components. (Use similar
material on all sources so your adjustments will reflect the output levels of the
source components rather than the differences in the program material.)
b) Use a keypad controller or the remote control to switch between the sources until you get a good feel for their
relative volume levels.
c) Adjust the V
OLUME OFFSET sliders of the four sources as needed to compensate for different output levels.
d) Transfer the new programming to the DAB1 via the USB connection. (See
Transferring System Information to a DAB1
,
on page 25.)
e) After the transfer is complete unplug the USB cable from the DAB1 and switch between the sources while they’re
playing to test your changes.
f) Repeat steps a) through e) as needed until all of the sources play at approximately the same volume.
NOTE: When a Zone Output Fixed/Variable button is in the F
IXED
position, the zone’s Source
Volume Offset adjustment is disabled for its Zone Line Outputs. See page 13.
Figure 43:
S
OURCE S
ETUP Screen