Roland Fantom-X6 CD Player User Manual


 
276
Effects List
20: SLICER
By applying successive cuts to the sound, this effect turns a
conventional sound into a sound that appears to be played as a
backing phrase. This is especially effective when applied to sustain-
type sounds.
fig.MFX-20
21: ROTARY
The Rotary effect simulates the sound of the rotary speakers often
used with the electric organs of the past. Since the movement of the
high range and low range rotors can be set independently, the
unique type of modulation characteristic of these speakers can be
simulated quite closely. This effect is most suitable for electric organ
Patches.
fig.MFX-21
22: VK ROTARY
This type provides modified response for the rotary speaker, with
the low end boosted further.
This effect features the same specifications as the VK-7’s built-in
rotary speaker.
fig.MFX-22
Parameter
Value Description
Step 01–16
L64–63R Level at each step
Rate # 0.05–10.00
Hz, note
Rate at which the 16-step sequence will
cycle
Attack # 0–127 Speed at which the level changes be-
tween steps
Input Sync
Sw
OFF, ON Specifies whether an input note will
cause the sequence to resume from the
first step of the sequence (ON) or not
(OFF)
Input Sync
Threshold
0–127 Volume at which an input note will be
detected
Mode LEGATO,
SLASH
Sets the manner in which the volume
changes as one step progresses to the
next.
LEGATO:
The change in volume from
one step’s level to the next remains
unaltered. If the level of a following
step is the same as the one preceding
it, there is no change in volume.
SLASH:
The level is momentarily set
to 0 before progressing to the level of
the next step. This change in volume
occurs even if the level of the follow-
ing step is the same as the preceding
step.
Shuffle # 0–127 Timing of volume changes in levels for
even-numbered steps (step 2, step 4, step
6...).
The higher the value, the later the beat
progresses.
Level 0–127 Output level
Parameter
Value Description
Speed #
SLOW, FAST Simultaneously switch the rota-
tional speed of the low frequency
rotor and high frequency rotor.
SLOW:
Slows down the rota-
tion to the Slow Rate.
FAST:
Speeds up the rotation
to the Fast Rate.
Woofer Slow
Speed
0.05–10.00 Hz Slow speed (SLOW) of the low
frequency rotor
Woofer Fast
Speed
0.05–10.00 Hz Fast speed (FAST) of the low fre-
quency rotor
L in
R in
L out
R out
Slicer
Slicer
Rotary
L out
R out
L in
R in
Woofer
Acceleration
0–15 Adjusts the time it takes the low
frequency rotor to reach the new-
ly selected speed when switch-
ing from fast to slow (or slow to
fast) speed. Lower values will re-
quire longer times.
Woofer Level 0–127 Volume of the low frequency ro-
tor
Tweeter Slow
Speed
0.05–10.00 Hz Settings of the high frequency ro-
tor
The parameters are the same
as for the low frequency rotor
Tweeter Fast
Speed
0.05–10.00 Hz
Tweeter
Acceleration
0–15
Tweeter Level 0–127
Separation 0–127 Spatial dispersion of the sound
Level # 0–127 Output Level
Parameter
Value Description
Speed #
SLOW, FAST Rotational speed of the rotat-
ing speaker
Brake # OFF, ON Switches the rotation of the
rotary speaker.
When this is turned on, the
rotation will gradually
stop. When it is turned off,
the rotation will gradually
resume.
Woofer Slow
Speed
0.05–10.00 Hz Low-speed rotation speed of
the woofer
Woofer Fast
Speed
0.05–10.00 Hz High-speed rotation speed of
the woofer
Woofer Trans
Up
0–127 Adjusts the rate at which the
woofer rotation speeds up
when the rotation is switched
from Slow to Fast.
Woofer Trans
Down
0–127 Adjusts the rate at which the
woofer rotation speeds up
when the rotation is switched
from Fast to Slow.
Woofer Level 0–127 Volume of the woofer
Tweeter Slow
Speed
0.05–10.00 Hz Settings of the tweeter
The parameters are the
same as for the woofer.
Tweeter Fast
Speed
0.05–10.00 Hz
Tweeter Trans
Up
0–127
Tweeter Trans
Down
0–127
Tweeter Level 0–127
Spread 0–10 Sets the rotary speaker stereo
image. The higher the value
set, the wider the sound is
spread out.
Low Gain -15– +15 dB Gain of the low range
High Gain -15– +15 dB Gain of the high range
Level # 0–127 Output Level
Parameter
Value Description
L out
R out
L in
R in
Rotary
2-Band EQ
2-Band EQ
Fantom-X678_r_e.book 276 ページ 2005年5月12日 木曜日 午後4時40分