Filter
Top Products
104
Playing in Performance Mode
Selecting in the Mixer Screen
1.
Press [MIXER] to access the MIXER screen.
2.
Use or to select a part.
3.
Use to move the cursor to the patch number.
fig.08-014
4.
Turn the VALUE dial or use [INC] [DEC] to select a patch.
Selecting the Rhythm Set
1.
Press [MIXER] to access the MIXER screen.
2.
Use or to select a part.
3.
Use to move the cursor to the following location.
fig.08-015
4.
Turn the VALUE dial or press [INC] [DEC] to select “R.”
The rhythm set will be selected.
In the Mixer screen you can set the following parameters for each
part.
Performance Mixer1 screen
Performance Mixer2 screen
1.
Press [MIXER].
The Performance Mixer 1 screen will appear.
* If you want to edit the parameters of the Performance Mixer 2 screen,
press [F6] to switch screens.
fig.04-016_50
2.
Use or to move the cursor to the parameter you
want to edit.
3.
Use or to move the cursor to the part that you want
to edit.
4.
Turn the VALUE dial or use [INC] [DEC] to set the desired
value.
The green border enclosing four parts corresponds to the four
REALTIME CONTROL knobs.
Editing the Part Settings
Parameter
Shown in the Mixer screen
as
Part Level (p. 108)
Level
Part Pan (p. 108) Pan
Part Reverb Send (p. 108) Rev
Part Chorus Send (p. 108) Cho
Solo Switch (p. 105) S
Mute Switch (p. 105) M
Parameter
Shown in the Mixer screen
as
Keyboard Switch (p. 110)
K
Arpeggio Part (p. 130) A
Pad Part (p. 161) P
Part Coarse Tune (p. 109) Key
Output Assign (p. 108) Output Assign
Fantom-X678_r_e.book 104 ページ ２００５年５月１２日 木曜日 午後４時４０分