Filter
Top Products
157
Editing a Sample
3.
Press [F5 (Time Strtch)].
fig.15-020_50
4.
Press or to select the parameter.
•
Edit Time Stretch
BPM:
Change the BPM of the sample to the BPM you
specify.
Time:
Specify the length of the sample as a time value.
Rate:
Specify the length relative to the current length of
the sample.
Value:
50.0–200.0%
•
Type
Lower settings of this value will make the sound more suitable
for faster phrases, and higher settings will make the sound
more suitable for slower phrases.
Value:
TYPE01–TYPE10
•
Quality Adjust
Make fine adjustments to the tonal quality of the Time Stretch.
Value:
1–10
5.
Use VALUE dial or [INC/DEC] to specify the tempo/length.
When setting the BPM (tempo) value, you can hold down
[SHIFT] and turn the VALUE dial, or use [INC] [DEC] to adjust
the value to the right of the decimal point.
6.
Press [F8 (Exec)].
A message will ask you for confirmation.
7.
To execute, press [F8 (Exec)].
The length of the sample will be changed as specified.
* To cancel, press [F7 (Cancel)].
The
chop
function divides a sample waveform into separate notes.
* The Create Rhythm function (p. 152) makes it easy to create a rhythm
set from a chopped sample.
* You cannot execute this with more than one sample selected.
1.
Press [SAMPLE EDIT] to access the Sample Edit screen.
2.
Press [F3 (Sample Modify)] to access the Sample Modify
window.
3.
Press [F3 (Chop)].
fig.15-021_50
Procedure for Dividing a Sample
You can freely specify the point(s) at which the sample is to be
divided.
4.
Press or to move the cursor to “Current Address.”
5.
Either turn the VALUE dial or use [INC], [DEC] to move the
point.
6.
At the location where you want to divide the sample, press
[F4 (Add Point)].
The current location will be the dividing point.
7.
Repeat steps 5 and 6 to specify other dividing points as
desired.
You can specify up to 15 locations at which to divide the
sample; i.e., the sample will be divided into a maximum of 16
pieces.
8.
Audition the sample as described in the section
“Auditioning the divided samples.”
If you want to re-make settings, press [F7 (Cancel)], and move
or delete the point (p. 158).
9.
Press [F8 (Exec)].
A message will ask you for confirmation.
10.
To execute the division, press [F8 (Exec)].
* To cancel, press [F7 (Cancel)].
When you execute the Chop operation, a message will ask
whether you want to execute Create Rhythm.
* The divided samples will be added to the sample list.
11.
If you want to execute Create Rhythm, press [F8 (Exec)].
For the rest of the procedure, refer to
“Create a Rhythm Set
(Create Rhythm)”
(p. 152).
12.
If you don’t want to execute Create Rhythm, press [F7
(Cancel)].
Dividing a Sample into
Notes (Chop)
Fantom-X678_r_e.book 157 ページ ２００５年５月１２日 木曜日 午後４時４０分