Filter
Top Products
43
Section 1. Recording and playing back
Section 1
1.
Hold down and press .
The time location will return to 00:00:00-00.0.
2.
Press .
Playback will begin.
The “repeat” function lets you play back a
specified region repeatedly. This function is
useful when you want to check the mix balance
repeatedly, or can be used in conjunction with
punch-in/out to perform Loop Recording (p. 47).
fig.01-570
1.
Move to the point where you want to
begin repeating (point A), and press
[A B].
Register the starting point (A) of the region
you want to repeat.
will blink, and that location will be
registered as the starting point (A) of the
repeated region.
2.
Move to the point where you want to stop
repeating (point B), and press [A B].
The display will appear the Select A B
Func message.
At this time, the “AB” indication will light,
indicating that the A-B region has been
assigned.
That location will be registered as the ending
point (B) of the repeated region.
fig.Disp-SET-AB.eps
* When specifying the repeat end point (B), pressing
[A B] at a point that is earlier than the repeat start
point (A) will cause that point to be reassigned as the
repeat start point (A).
* There must be at least one second between the repeat
start point (A) and end point (B). You can’t specify an
end point that’s less than one second away from the start
point.
3.
Press [TR1] (REP).
The region you specified will be assigned as
the repeat region. and will be lit.
Playing back
Playing back repeatedly
(Repeat)
Repeat
Repeat start point (A) Repeat end point (B)
Time