Filter
Top Products
21
Getting ready to use the MICRO BR
928
929
930
931
fig.eject-sd-j.eps
To remove the memory
card
Push it inward, and then release your
finger.
fig.sd-protect.eps
About the memory card write protect
function (Lock)
By moving the write protect switch located on the side of the
memory card to the “LOCK” position, you can make it impossible
for data to be written and erased to the card.
1. Push
2. Release your finger
Write
Protect
• We recommend that you use alkaline batteries.
• Don’t mix new batteries with partially used batteries, and don’t mix batteries of different types.
• If you use rechargeable batteries, be sure to carefully read the instructions that came with your batteries.
The MICRO BR itself is not able to recharge rechargeable batteries.
• When the icon appears, replace the batteries as soon as possible.
• The battery operating time will depend on the type of batteries and on the operating conditions. It will
also vary depending on the type and capacity of the SD memory card.
• Keep the included memory card out of reach of small children to prevent it from being swallowed
accidentally.
• For more about the memory cards (SD cards) recommended for use with the MICRO BR, refer to the
separate leaflet “About memory cards.”
• Insert memory cards all the way into the slot, being careful to observe the correct direction and
orientation. Do not insert them forcibly.
• Don’t touch the contacts of a memory card or allow them to become dirty.
• The power must be turned off when you insert or remove a memory card. Inserting or removing a
memory card while the power is on may damage the data on the card or render the memory card
unusable.
• When turning the unit upside-down, get a bunch of newspapers or magazines, and place them under the
four corners or at both ends to prevent damage to the buttons and controls. Also, you should try to orient
the unit so no buttons or controls get damaged.
• When turning the unit upside-down, handle with care to avoid dropping it, or allowing it to fall or tip
over.
• Never insert or remove a SD card while this unit’s power is on. Doing so may corrupt the unit’s data or
the data on the SD card.
• Carefully insert the SD card all the way in—until it is firmly in place.
MICRO-BR_e1.book 21 ページ ２００６年８月１日 火曜日 午後１２時６分